Frymaster Pre-Installation cont, TB14 SERIES GAS FRYERS IMPORTANT INFORMATION, Danger

Page 10
TB14 SERIES GAS FRYERS

TB14 SERIES GAS FRYERS

CHAPTER 2: IMPORTANT INFORMATION

2.4Pre-Installation (cont.)

2.Frymaster TB14 Series gas fryers require 120VAC 60 cycle or 230VAC single-phase 50- hertz (International/CE) electrical service and are equipped with a 16-3 SJT grounded flexible power cord for a direct connection to the power supply. Amperage draw for each unit depends on the accessories supplied with the unit/system.

B.Clearances: The fryer area must be kept free and clear of all combustibles. This unit is design- certified for the following installations:

1.Commercial installation only (not for household use).

2.Non-combustible floor installation equipped with factory-supplied 6-inch (15-cm) adjustable legs or 5-inch (13-cm) casters;

3.Combustible construction with a minimum clearance of 6-inches (15-cm) side and 6-inches (15-cm) rear, and equipped with factory-supplied 6-inch (15-cm) adjustable legs or 5-inch

(13-cm) casters.

2.4Pre-Installation (cont.) DANGER

Local building codes usually prohibit a fryer with its open tank of hot oil from being installed beside an open flame of any type, whether a broiler or the open burner of a range.

C. Installation Standards:

1. U.S. installations must meet:

2. Canadian installations must meet:

American National Standard Institute

CAN 1-B149 Installation Codes

ANSI Z83.11

Canadian Gas Association

American Gas Association

55 Scarsdale Road

8501 E. Pleasant Valley Road

Don Mills, ONT, M3B 2R3

Cleveland, OH 44131

 

National Electrical Code

Canadian Electric Code c22.1, part 1

ANSI/NFPA #70

Canadian Standards Association

American National Standard Institute

178 Rexdale Blvd.

1430 Broadway

Rexdale, ONT, M9W 1R3

New York, NY 10018

 

NFPA Standards #96 and #211

 

National Fire Protection Association

 

470 Atlantic Avenue

 

Boston, MA 02110

 

 

 

2-2

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Installation & Operation Manual PARTS LIST INCLUDEDTB14 Series With Built-In Filtration 8195941REQUIREMENTS in Chapter 3 of this manual for specifics from slips or contact with the hot oil DANGER other appliance DANGERTB14 Series Gas Fryers TABLE OF CONTENTSPage # TABLE OF CONTENTS CONT 1.1 After Purchase 1.3 Service InformationTB14 SERIES GAS FRYERS CHAPTER 1 INTRODUCTION 1.2 Ordering Parts1.4 Computer Information cont 1.5 Safety Information1.6 Service Personnel TB14 SERIES GAS FRYERS CHAPTER 1 INTRODUCTIONC. Qualified Service Personnel B. Qualified Installation PersonnelTB14 SERIES GAS FRYERS CHAPTER 1 INTRODUCTION 1.6.1 Definitions cont 2.1 Product Description 2.4 Pre-InstallationTB14 SERIES GAS FRYERS CHAPTER 2 IMPORTANT INFORMATION 2.2 Principles of OperationC. Installation Standards 2.4 Pre-Installation contTB14 SERIES GAS FRYERS CHAPTER 2 IMPORTANT INFORMATION 2.5 Air Supply and Ventilation 2.6 Equipment Installed at High AltitudesA. Do not connect this fryer to an exhaust duct 2.7 Receiving and Unpacking Equipment If your equipment arrives damaged3.2 Leveling the Fryer fryers equipped with legs only TB14 SERIES GAS FRYERS CHAPTER 3 INSTALLATION3.1 Installing the Fryer movement to avoid damage and possible bodily injury DANGERTB14 SERIES GAS FRYERS CHAPTER 3 INSTALLATION 3.3 Installing Casters and LegsQuestions? Call NATIONAL CODE REQUIREMENTS 3.4 Gas ConnectionsRecommended Gas Supply Line Sizes ½ PSI 3.45 kPa/35 mbar, a step-down regulator will be required 3.4 Gas Connections contdamage to the fryer’s gas piping and gas valves injury may result new connectionsI. Flexible Couplings, Connectors and Casters 3.5 Electrical Connections TB14 SERIES GAS FRYERS CHAPTER 4 FRYER OPERATIONS 4.1.1 Pilot Lighting Procedures, Standing Pilot Only4.1 Initial Start-up 4.1.1 Pilot Lighting Procedures, Standing Pilot Only cont TB14 SERIES GAS FRYERS CHAPTER 4 FRYER OPERATIONS4.2 Boil-Out Procedure 4.3 Final Preparation 4.2 Boil-Out Procedure contso will damage the heating tubes and frypot, and void the warranty crack glass containersTB14 SERIES GAS FRYERS CHAPTER 5 BUILT-IN FILTRATION transfer5.1 General TB14 SERIES GAS FRYERS CHAPTER 5 BUILT-IN FILTRATION5.2 Filtration Preparation 5.2.1 Assembling the Filter5.2.1 Assembling the Filter cont Assemble the filter as follows4. Sprinkle 8 ounces of filter powder on the filter sheet. Ensure the powder covers the filter paper evenly 5.3 Daily Filtration Operation 5.2.2 Installing the Filter5.3.1 General Overview 5.3.2 Filtering Tools 5.4 Operating the Filtercontainer for disposal above the maximum fill line located on the container DANGER 5.4 Operating the Filter contoverflow and spillage of hot oil/shortening DANGER shortening will rush out creating the potential for severe burnstemperature ~350F ~177C 5.4.2 Filter Operation1. Turn the fryer off. Ensure the filter pan assembly is prepared as described in Section 5.2.1- Assembling the Filter 5.4.2 Filter Operation cont 5-105-11 5-12 5-13 DO NOT ALLOW CRUMBS TO ACCUMULATE IN TRAYwater. NEVER allow water to enter the Filtration System TB14 SERIES GAS FRYERS CHAPTER 6 COMPUTER OPERATION6.1 Operating Fryers with Computer Magic III.5 Computers DESCRIPTIONTB14 SERIES GAS FRYERS CHAPTER 6 COMPUTER OPERATION 6.1.1 Equipment Setup and Shutdown ProceduresSetup ShutdownDo not cancel the melt cycle mode if using solid shortening 6.1.1 Equipment Setup and Shutdown Procedures contresults, do not cook product until the display reads 6.2 Programming the Computer Magic III.5 Computer 6.1.2 Checking Temperature6.2.1 Boil Feature 6.2 Programming the Computer Magic III.5 Computer cont6.2.2 Temperature Selection-Fahrenheit to Celsius 6.2.1 Boil Feature contSEE CHAPTER 4.2 FOR ADDITIONAL BOIL-OUT PROCEDURES 6.2.3 Constant Oil Temperature Display Mode7.1 General TB14 SERIES GAS FRYERS CHAPTER 7 PREVENTATIVE MAINTENANCEtime the cleaner remains on the food-contact surfaces 7.2 Daily7.4 Periodic/Annual TB14 SERIES GAS FRYERS CHAPTER 7 PREVENTATIVE MAINTENANCEBuilt-in Filtration Built-in Filtration cont 7.4 Periodic/Annual cont7.5 Stainless Steel Care burnsDisconnect all power cords before servicing TB14 SERIES GAS FRYERS CHAPTER 8 TROUBLESHOOTINGtests are required. Use extreme care when performing such tests authorized service agent only8.2 Pilot Burner Malfunction cont TB14 SERIES GAS FRYERS CHAPTER 8 TROUBLESHOOTING8.3 Main Burner Malfunctions 8.3 Main Burner Malfunctions cont 8.4.1 WiringDiagrams TB14 SeriesDual Operation Only 8.4.2 TB14 Series Interface Board Enlarged ViewTerminal #2 - Medium PART # TB14 SERIES GAS FRYERS CHAPTER 9 PARTS LIST9.1 Accessories COMPONENTTB14 SERIES GAS FRYERS CHAPTER 9 PARTS LIST 9.2 Cabinetry and Related Components9.2 Cabinetry and Related Components cont 1 823-3248 Support, Leg- Without Optional SUFF Filter Only9.3 Computer and Related Components To Frypot 9.4 Filter Module ComponentsTo Filter 9.4 Filter Module Components cont 9.5 Filter Pan Components 9.6 Frypot, Burners and Related Components 9.6 Frypot, Burners and Related Components cont 9.7 Oil Return Components FAX Parts 1-318-219-7140 FAX Tech Support SERVICE HOTLINEShipping Address 8700 Line Avenue, Shreveport, Louisiana Price $10.00
Top Page Image Contents