Frymaster Installing Casters and Legs, TB14 SERIES GAS FRYERS INSTALLATION, Questions? Call

Page 14
TB14 SERIES GAS FRYERS

TB14 SERIES GAS FRYERS

CHAPTER 3: INSTALLATION

3.3Installing Casters and Legs

A.Install casters and/or legs near where the fryer is to be used, as neither is secure for long transit. TB14 Series gas fryers cannot be curb mounted and must be equipped with either legs or casters provided.

B.After unpacking, use a pallet or lift jack to raise the unit before installing the casters.

C.Align the caster or leg base holes with the leg support assembly and insert bolt. Install the washers and nut hand tight, and repeat for all four holes in caster/leg base assembly.

D.Tighten the caster/leg against the leg support assembly by using appropriate tools. Ensure that all four bolts are evenly tightened.

E.For fryers with casters, there are no built-in leveling devices. The floor where the fryers are installed must be level.

Front ViewRear Side View

 

1/4-20 x 3/4 Hex Bolt

 

Front Channel or

Front Channel

Rear Channel

Leg Support Assembly

or Rear Channel

Washer

 

1/4-20 Hex Head Locknut

Optional Caster-

Optional Caster-

Rear Only

 

Front Only

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Front or Rear Leg with Mounting Plate

1/4-20 x 3/4 Hex Bolt

Adjust as needed 3.3Installing Casters and Legs

Rear Caster—5" Rigid

Front Caster—5" Swivel

w/Brake

Caster/Leg Installation and Adjustment

Questions? Call 1-800-551-8633 WARNING

Frymaster fryers equipped with legs are for permanent installations. Fryers fitted with legs must be lifted during movement to avoid damage and possible bodily injury. For a moveable or portable installation, Frymaster optional equipment casters must be used.

Questions? Call 1-800-551-8633

3-2

Image 14
Contents Installation & Operation Manual PARTS LIST INCLUDEDTB14 Series With Built-In Filtration 8195941REQUIREMENTS in Chapter 3 of this manual for specifics from slips or contact with the hot oil DANGER other appliance DANGERPage # TABLE OF CONTENTSTB14 Series Gas Fryers TABLE OF CONTENTS CONT 1.1 After Purchase 1.3 Service InformationTB14 SERIES GAS FRYERS CHAPTER 1 INTRODUCTION 1.2 Ordering Parts1.4 Computer Information cont 1.5 Safety Information1.6 Service Personnel TB14 SERIES GAS FRYERS CHAPTER 1 INTRODUCTIONTB14 SERIES GAS FRYERS CHAPTER 1 INTRODUCTION 1.6.1 Definitions cont B. Qualified Installation PersonnelC. Qualified Service Personnel 2.1 Product Description 2.4 Pre-InstallationTB14 SERIES GAS FRYERS CHAPTER 2 IMPORTANT INFORMATION 2.2 Principles of OperationTB14 SERIES GAS FRYERS CHAPTER 2 IMPORTANT INFORMATION 2.4 Pre-Installation contC. Installation Standards A. Do not connect this fryer to an exhaust duct 2.6 Equipment Installed at High Altitudes2.5 Air Supply and Ventilation 2.7 Receiving and Unpacking Equipment If your equipment arrives damaged3.2 Leveling the Fryer fryers equipped with legs only TB14 SERIES GAS FRYERS CHAPTER 3 INSTALLATION3.1 Installing the Fryer movement to avoid damage and possible bodily injury DANGERQuestions? Call 3.3 Installing Casters and LegsTB14 SERIES GAS FRYERS CHAPTER 3 INSTALLATION Recommended Gas Supply Line Sizes 3.4 Gas ConnectionsNATIONAL CODE REQUIREMENTS damage to the fryer’s gas piping and gas valves 3.4 Gas Connections cont½ PSI 3.45 kPa/35 mbar, a step-down regulator will be required I. Flexible Couplings, Connectors and Casters new connectionsinjury may result 3.5 Electrical Connections 4.1 Initial Start-up 4.1.1 Pilot Lighting Procedures, Standing Pilot OnlyTB14 SERIES GAS FRYERS CHAPTER 4 FRYER OPERATIONS 4.1.1 Pilot Lighting Procedures, Standing Pilot Only cont TB14 SERIES GAS FRYERS CHAPTER 4 FRYER OPERATIONS4.2 Boil-Out Procedure 4.3 Final Preparation 4.2 Boil-Out Procedure contso will damage the heating tubes and frypot, and void the warranty crack glass containersTB14 SERIES GAS FRYERS CHAPTER 5 BUILT-IN FILTRATION transfer5.1 General TB14 SERIES GAS FRYERS CHAPTER 5 BUILT-IN FILTRATION5.2 Filtration Preparation 5.2.1 Assembling the Filter5.2.1 Assembling the Filter cont Assemble the filter as follows4. Sprinkle 8 ounces of filter powder on the filter sheet. Ensure the powder covers the filter paper evenly 5.3.1 General Overview 5.2.2 Installing the Filter5.3 Daily Filtration Operation container for disposal 5.4 Operating the Filter5.3.2 Filtering Tools above the maximum fill line located on the container DANGER 5.4 Operating the Filter contoverflow and spillage of hot oil/shortening DANGER shortening will rush out creating the potential for severe burns1. Turn the fryer off. Ensure the filter pan assembly is prepared as described in Section 5.2.1- Assembling the Filter 5.4.2 Filter Operationtemperature ~350F ~177C 5.4.2 Filter Operation cont 5-105-11 5-12 5-13 DO NOT ALLOW CRUMBS TO ACCUMULATE IN TRAYwater. NEVER allow water to enter the Filtration System TB14 SERIES GAS FRYERS CHAPTER 6 COMPUTER OPERATION6.1 Operating Fryers with Computer Magic III.5 Computers DESCRIPTIONTB14 SERIES GAS FRYERS CHAPTER 6 COMPUTER OPERATION 6.1.1 Equipment Setup and Shutdown ProceduresSetup Shutdownresults, do not cook product until the display reads 6.1.1 Equipment Setup and Shutdown Procedures contDo not cancel the melt cycle mode if using solid shortening 6.2 Programming the Computer Magic III.5 Computer 6.1.2 Checking Temperature6.2.1 Boil Feature 6.2 Programming the Computer Magic III.5 Computer cont6.2.2 Temperature Selection-Fahrenheit to Celsius 6.2.1 Boil Feature contSEE CHAPTER 4.2 FOR ADDITIONAL BOIL-OUT PROCEDURES 6.2.3 Constant Oil Temperature Display Mode7.1 General TB14 SERIES GAS FRYERS CHAPTER 7 PREVENTATIVE MAINTENANCEtime the cleaner remains on the food-contact surfaces 7.2 DailyBuilt-in Filtration TB14 SERIES GAS FRYERS CHAPTER 7 PREVENTATIVE MAINTENANCE7.4 Periodic/Annual Built-in Filtration cont 7.4 Periodic/Annual cont7.5 Stainless Steel Care burnsDisconnect all power cords before servicing TB14 SERIES GAS FRYERS CHAPTER 8 TROUBLESHOOTINGtests are required. Use extreme care when performing such tests authorized service agent only8.3 Main Burner Malfunctions TB14 SERIES GAS FRYERS CHAPTER 8 TROUBLESHOOTING8.2 Pilot Burner Malfunction cont 8.3 Main Burner Malfunctions cont 8.4.1 WiringDiagrams TB14 SeriesTerminal #2 - Medium 8.4.2 TB14 Series Interface Board Enlarged ViewDual Operation Only PART # TB14 SERIES GAS FRYERS CHAPTER 9 PARTS LIST9.1 Accessories COMPONENTTB14 SERIES GAS FRYERS CHAPTER 9 PARTS LIST 9.2 Cabinetry and Related Components9.2 Cabinetry and Related Components cont 1 823-3248 Support, Leg- Without Optional SUFF Filter Only9.3 Computer and Related Components To Filter 9.4 Filter Module ComponentsTo Frypot 9.4 Filter Module Components cont 9.5 Filter Pan Components 9.6 Frypot, Burners and Related Components 9.6 Frypot, Burners and Related Components cont 9.7 Oil Return Components FAX Parts 1-318-219-7140 FAX Tech Support SERVICE HOTLINEShipping Address 8700 Line Avenue, Shreveport, Louisiana Price $10.00