Frymaster SM35 operation manual Gas Conversion Procedures, On/Pilot/Off

DEAN MILLIVOLT GAS FRYERS (NON-CE)

CHAPTER 3: INSTALLATION INSTRUCTIONS

3.7 Gas Conversion Procedures

See gas valve illustration below and gas valve, burner and orifice location on page 3-11 when performing the following conversions.

When converting from natural gas to propane (or vice-versa), the following procedures apply:

♦Burner orifices and pilot orifice MUST be replaced (See page 3-9 for required component part numbers).

♦Adjust orifice gas pressure by turning the gas-valve adjustment screw (See page 3-9 for various gas types and pressures).

♦After adjustment, replace the adjustment-screw cover.

♦Affix the new label included with the conversion kit next to the exiting rating plate stating that the gas type has been converted. Remove any references to the previously used gas from the existing rating plate.

Conversion from one gas family to another (i.e. changing from natural gas to propane) requires special components. Obtain the necessary components using the tables on page 3-9.

Conversions can only be executed by qualified, factory-authorized personnel.

ON/PILOT/OFF
Gas-Cock Knob	Pressure flow adjustment
	(remove cover screw to access)
Pilot pressure adjustment	Regulator Vent
(remove cover screw to access)
	Pilot gas supply connection
	Pressure Tap

Typical gas valve (Millivolt- Non-CE).

3-10