Jenn-Air JGD8430 important safety instructions Electrical Connection, Ducting Information

IMPORTANT SAFETY INSTRUCTIONS

fuels. Properly adjusted burners will minimize incomplete combustion. Exposure to these substances can also be minimized by properly venting the burners to the outdoors.

IMPORTANT NOTICE REGARDING PET BIRDS: Never keep pet birds in the kitchen or in rooms where the fumes from the kitchen could reach. Birds have a very sensitive respiratory system. Fumes released during an oven self-cleaning cycle may be harmful or fatal to birds. Fumes released due to overheated cooking oil, fat, margarine and overheated non-stick cookware may be equally harmful.

Electrical Connection

Appliances which require electrical power are equipped with a three-prong grounding plug which must be plugged directly into a properly grounded three-hole 120 volt

electrical outlet.

Always disconnect power to appliance before servicing.

The three-prong grounding plug offers protection against shock hazards. DO NOT CUT OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD PLUG.

If an ungrounded, two-hole or other type electrical outlet is encountered, it is the personal responsibility of the appliance owner to have the outlet replaced with a properly grounded three-hole electrical outlet.

Ducting Information

Jenn-Air’s ventilation system is designed to capture both cooking fumes and smoke from the cooktop surface. If the system does not, these are some ducting installation situations to check:

•6” diameter round or 3 1/4” x 10” rectangular ducting should be used for duct lengths 10’-60’.

Note: Use 5” diameter round ducting if the duct length is 10' or less.

•No more than three 90° elbows should be used. Distance between elbows should be at least 18”.

•Recommended Jenn-Air wall cap MUST be used. Make sure damper moves freely when ventilation system is operating.

•There should be a minimum clearance of 6” for cooktop installed near a side wall.

•There should be a minimum clearance of 12” between the bottom of the wall cap and the ground.

If there is not an obvious improper installation, there may be a concealed problem such as a pinched joint, obstruction in the pipe, etc. Installation is the responsi- bility of the installer and questions should be addressed first by the installer. The installer should very carefully check the ducting installation instructions.

• Use the Flow Tester Card provided with your appliance to check the air flow.

Save These Instructions for Future Reference

4