
5.While holding the connector securely against the lacing bracket, tighten the tie wrap, then remove any excess length.
The LockIt bracket can also be used in a stacked formation, as shown below.
Side Mounted | Stacked |
Figure 2. LockIt Bracket Mounting Options
DAudio inputs
Tip |
Ring |
Sleeves |
Tip |
Ring |
L R
Tip
Sleeve
Tip
Sleeve
L R
Balanced Stereo Input | Unbalanced Stereo Input | |
Figure 3. | Audio Input Connector Wiring | |
NOTE: | Control signal ground pins are labeled “G”. Audio ground pins are as . | |
| The wiring and function are the same, whichever way your product is labeled. |
E HDMI output — Connect an HDMI display device to this HDMI connector. |
NOTE: All video outputs (HDMI, VGA, SDI) share a common output resolution and display |
the same content. |
F RGB or HD component |
video display or HD component video display to this HD |
NOTE: Simultaneous identical scaled outputs for HDMI and analog RGB or HD |
component video are available. |
G Optional |
interface) display to this female BNC connector for SDI output. This complies with |
SMPTE 292M and 424M and ITU video digital standards. |
NOTE: |
1080p, or 2k 23.98/24/25 hz. |
H Genlock connector and loop through (SDI models only) — Connect an external |
reference signal for synchronization of the SDI output. The loop through can be used |
to synchronize additional devices. |
DVS 605 • Rear Panel Connections | 9 |