Extron electronic DVS 605 manual DVS using the LockIt bracket as follows

APower input — Connect the standard IEC power cord from a 100 to 240 VAC, 50-60 Hz power source into this connector. The front panel control and input selection buttons light in sequence during power-up.

BInputs 1 and 2 — Connect suitable inputs to these two universal analog input ports (15-pin HD [VGA] connectors) for auto-detection of RGB, HD component video, YUVi, S-video, or composite video signals.

These universal analog input ports can be configured to accept RGB (RGBHV, RGBs), component video (bi- or tri-level), S-video, or composite video signals. The default setting is for auto detect. The table below shows the pinouts for each format type on the 15-pin HD (VGA) connector. The 15-pin HD supports EDID emulation.

Pinout Table for 15-pin HD Connector

Pin	RGBHV	RGBs	Component	S-video	Composite
1	Red	Red	R-Y
2	Green	Green	Y	Luma	Video
3	Blue	Blue	B-Y	Chroma
4	No	No
	Connection	Connection
5	No	No
	Connection	Connection
6	Red Return	Red Return	R-Y Return
7	Green Return	Green Return	Y Return	L Return	Video Return
8	Blue Return	Blue Return	B-Y Return	C Return
9
10	Ground	Ground
11	No	No
	Connection	Connection
12	EDID/DDC	EDID/DDC	5	1
13	H Sync	C Sync
14	V Sync
15	EDID/DDC	EDID/DDC	15	11

CInputs 3 to 5 — Connect HDMI sources to these three HDMI connectors.

Audio from the HDMI inputs can be de-embeded from the HDMI source. This allows the user to choose to select audio either from the HDMI inputs or the analog audio captive screw inputs. Once an audio source is selected, the unselected source is disabled. The default selection is 2-channel digital audio from the HDMI inputs.

Connect up to three digital HDMI and DVD-D inputs to the HDMI connectors C. Connect DVI-D sources using an adapter cable and secure the connectors to the

DVS using the LockIt™ bracket as follows: 1

1.Plug the HDMI cables into the panel connections.

2.Loosen the side HDMI connection mounting screw from the panel enough to allow the LockIt lacing bracket to be placed over it.

3.Place the LockIt lacing bracket onto the screw and slide it up against the HDMI connector. Tighten the screw to secure the bracket.

4.Loosely place the included tie wrap around the HDMI connector and LockIt lacing bracket.

2

3

4

DVS 605 • Rear Panel Connections 8