Extron electronic DVS 605 manual Hardwired IR port, Picture In Picture, PIP on/off, Reset commands

Command	ASCII Command	Response	Additional Description
	(host to scaler)	(scaler to host)
Hardwired IR port
Enable IR port	65*0#	IRDisable0]	Enables the hard wired port and allows IR
(allows IR)			control input.
Disable IR port	65*1#	IRDisable1]	Disables the hard wired port (default).
(blocks IR)
View IR setting	65#	X(]	View the current IR Disable setting.

Picture In Picture

NOTE: HDMI input 5 cannot be used for PIP.

PIP on/off

PIP on	EX2&PIP}	PipX2&]	Turn on PIP and display input X2&. X2& is a
			two digit response (for example, 01).
PIP off	E0PIP}	Pip00]	Turn PIP off.
View PIP selection	EPIP}	X2&]	View PIP selection (X2& is a two digit
			response, for example, 01).
Swap main/PIP windows
Swap	%	Tke]	Swap between main and PIP window.

On-Screen Menu time-out

NOTE: Setting the time-out to 501 disables the OSD time-out (never times out). Setting the time-out to 0 disables the OSD.

Set menu time-out	EX2%MDUR}	MdurX2%]	Set the OSD to X2% seconds.
View time-out	EMDUR}	X2%]	View time-out settings.

Reset commands

Erase user web	E<filename>EF}	Del•<filename>]	Erase named files.
pages and files 24 28
Erase current	E/EF}	Ddl]	Erase current directory and its files.
directory and
files 24 28
Erase current	E//EF}	Ddl]	Erase current directory and its
directory and			subdirectories.
subdirectories 24 28
Erase flash	EZFFF}	Zpf]	Erase the flash memory.
memory 24
Reset all device	EZXXX}	Zpx]	Retains Ethernet settings
settings to factory
default settings 24
Absolute system	EZQQQ}	Zpq]	Includes resetting networking to DHCP =
reset 24			Off, IP = 192.168.254.254 (default address)
Absolute system	EZY}	Zpy]
reset (but retain IP) 24

NOTE: This reset EZY is similar to ZQQQ but excludes IP address, subnet mask, gateway addresses, unit name,

DHCP setting, and port mapping (Telnet/web/direct access) in order to maintain communications with device. Recommended after a firmware update.

NOTE: X( = Enable/disable: 0 = off/disable, 1 = on/enable

X2% = On-screen menu time-out: (default = 3 seconds)/output sync time-out (default = 501 - never)

0 = OSD never displayed/output sync is instantly disabled with no active input,

1 to 500 in 1 second increments, 501 = OSD never times out/output sync never times out

X2& = PIP window input selection: 0 to 4 (0 = off)

DVS 605 • SIS Communication and Control 54