Extron electronic DVS 605 manual View Comm Settings, Exit Menu, Temperature, Factory Reset

Page 32

Temperature

Temperature

This is a read-only menu that gives the internal temperature (degrees C and F) of the connected device. No adjustments can be made.

Factory Reset

This menu allows the user to reset the device to the factory default settings.

Press and hold the Auto-Image button until the display changes. Release and press Auto-Image again to confirm that a reset is desired. The device will be reset.

View Comm Settings

The current RS-232 and IP settings are read-only with this menu. To make any setting adjustments, the “hidden” Edit Comm Settings menu must be accessed (see below).

Press Next to go through each sublevel to view the following: serial port (baud rate and communication type), MAC address (cannot be changed), DHCP status (on or off),

IP address, subnet mask, and gateway address.

NOTE: To enter the “hidden” Edit Comms Settings menu, press and hold in the input

5 and Next buttons simultaneously. The Edit Comms Settings menu appears.

EDIT COMM	Next
EDIT COMM
SETTINGS
“Hidden” Menu

			Next
	SERIAL PORT		Next
	SERIAL PORT
	9600	RS232

Rotate to change baud rate.

DHCP MODE			Next
			Next

<On>

Rotate either to turn DHCP mode On or Off.

I	192.168		Next
			Next

P	254.254

Rotate to select octet field. Rotate to change IP address.

Next

S	255.255		Next
M	000.000

Rotate to select octet field. Rotate to change subnet mask address.

G	192.168
W	000.000
	Rotate	to select
	octet field. Rotate
	to change gateway
	address.

Figure 21. Edit Comm Settings Menu

Exit Menu

From this submenu, press the Menu button to return to the User Presets menu cycle, or press the Next button to exit the menu and return to the default cycle.

DVS 605 • Operation

26

Image 32

Contents SCALERS AND SIGNAL PROCESSORS with Seamless SwitchingUser Guide HDCP-CompliantScalerSafety Instructions Safety Instructions • EnglishChinese Simplified（简体中文） Instructions de sécurité • FrançaisTrademarks FCC Class A NoticeCopyright Specifications Availability Software CommandsConventions Used in this Guide NotificationsSIS Communication and Control ContentsUsing the Default Web Pages Mounting the DVS Introduction DVS 605 Series DescriptionLicensed Third-partySoftware Used in the DVS Licensed Third-partySoftware Used in the DVSPackage LicenseVideo Outputs Key FeaturesVideo Inputs DVS 605 • Introduction AudioGeneral DVS 605 • Introduction Controlling the DVS DVS 605 Rear Panel Features — All Models Rear Panel ConnectionsRear Panel Cabling FigureDVS using the LockIt bracket as follows Figure Audio Input Connector WiringFigure 2. LockIt Bracket Mounting Options Figure 6. RJ-45LAN Connector Wiring Figure 4. Audio Output Connector WiringFigure 5. Audio Output Connector Wiring DVS 605 • Rear Panel Connections •Front Panel Overview •Powering Up •Other DVS 605 Operating FeaturesFigure 7. DVS 605 Front Panel Features OperationPowering Up Default Display CycleMenu Navigation Using Front Panel Controls Figure 8. Typical Default Display CycleMenu Overview Figure 9. Top Level MenusFigure 10. Main Menu DVS 605 • OperationUser Presets Figure 11. User Preset MenuPicture Control Figure 12. Picture Control MenuInput Configuration Figure 13. Input Configuration MenuInput video types InputFigure 14. Output Configuration Menu Output ConfigurationResolutions and Refresh Rates Analog Output Format Sync PolarityHDMI Format HDCP NotificationGenlock/AFL Modes HDCP Status: Inputs & OutputsHDCP Authorized Genlock/AFL Offset Description Figure 17. Audio Configuration Menu Audio Configuration All ModelsAudio Delay Setting Aspect Ratio Advanced ConfigurationFigure 18. Advanced Configuration Menu Auto Memory Auto-Imagethreshold settingsAuto-Image Switch type OverscanTest pattern OSD durationView Comm Settings Factory ResetFigure 21. Edit Comm Settings Menu Exit MenuFront Panel Lockout Executive Modes Figure 22. Front Panel LockoutEnable Executive Mode Disable Executive ModeWindow vs. Image Size Position — An Overview DVS 605 OperationNOTES Picture-in-picturePIP ModeFront Panel Activation PIP Presets Figure 24. Default Main and PIP Window LayoutsOther DVS 605 Operating Features Power SaveCustom EDID/Custom Output Resolution Screen SaveHardwired IR Port The OSD BugAudio Format Audio SourceResetting the Unit DVS 605 Reset Mode SummaryFigure 25. Reset Mode Comparison Reset All IP Reset to Factory Defaults SettingsSIS Communication and Control Copyright Information•Commands and Responses Host to Scaler CommunicationsCommands and Responses Password InformationError Responses Error Response ReferencesSymbol Definitions DVS 605 • SIS Communication and ControlFigure 29. SIS Command EDID Table DVS 605 SIS Communication and ControlDVS 605 SIS Communication and Control DVS 605 • SIS Communication and Control SIS IP command definitions DVS 605 • SIS Communication and ControlDVS 605 • SIS Communication and Control SIS Command and Response Table CommandASCII Command ResponseAdditional Description Input nameAuto-Image Horizontal startCommand ASCII CommandResponse Additional DescriptionPicture Adjustments Video muteColor TintHorizontal position window Vertical position windowHorizontal position image Vertical position imageOutput Configuration Power save modeHorizontal size image Output scaler rateAudio Configuration Audio mute global settings Volume control audio models onlyAudio delay available on all models CommandAudio input format Audio output formatAudio follow CommandPresets User presets User preset nameInput presets Input preset nameAdvanced Configuration Test patternFreeze Auto memories per inputVideo effect Effect durationFront panel security lockout Executive Mode HDCP notification green screen/messageVideo signal presence GenlockGenlock/AFL Offset CommandHardwired IR port Reset commandsPicture In Picture PIP on/offBackup/restore configuration Information requestProduct naming CommandEthernet data port Firmware version requestsCommand ASCII TelnetIP setup commands Information requestsCommand ASCII TelnetNOTE: E X12!CA Directory commands File erase commandsRe-mapport designations CommandUsing the Default Web Pages Accessing the Default Web Pages•Accessing the Default Web Pages Navigating the Default Web PagesTurning Off Compatibility Mode Navigating the Default Web PagesTo check compatibility view settings Configuration Pages AV Controls PanelAuto-Imagebutton AV input buttons inputsFreeze button Breakaway audio check box audio models onlyVideo and audio mute buttons Signal type Figure 34. Input Configuration PanelInput renaming RGB ScaledAspect ratio Film DetectAuto-Image Auto MemoryResolution Analog signal formatFigure 35. Input Configuration Panel Refresh rateDigital output signal format Switch transitionGenlock Test patternEDID Minder Page Figure 36. EDID Minder PageAssigning EDIDs Figure 37. Assigning EDIDsFigure 38. Image Settings Page Image Settings PageSignal Sampling User Presets Settings Included Within PresetsSetting User PresetInput Presets OverscanPIP Settings Page Figure 40. PIP Settings PagePIP input selection Snap PIP toPIP picture controls Size and PositionHorizontal Size and Vertical Size fields Horizontal Pos and Vertical Pos fieldsPIP presets Figure 41. PIP Preset Default Window LocationsAudio Settings Page Figure 42. Audio Config PageNone •2-CHDigital •Full DigitalDual Mono StereoPreset Management Page Figure 43. Preset Management Pagea.Recall: Inputs, Size & Position, or b.Recall: Size & Position OnlyDevice Settings Page Figure 44. Device Settings PageScreen Saver Settings 1.Select the Enable On Screen Display check boxOn Screen Display Message HDCP NotificationAuto Switch Hardware Pages Unit Information PageFigure 46. Unit Information Page See Licensed Third-partySoftware Used in theConnection Settings Page Figure 48. Connection Settings PageDevice Name Page Figure 47. Device Name PageRS-232Settings Ethernet SettingsFirmware Loader Page Figure 49. Firmware Loader PageExecutive Mode Executive/Power Mode PageFigure 50. Executive/Power Mode Page Power Mode Date and Time PageMute Video and Sync Figure 51. Date and Time PagePassword Page Figure 52. Password Pagedevice name, DHCP setting, and port mapping Reset Device PageFigure 53. Reset Device Page Tabletop Placement MountingMounting the DVS UL Guidelines for Rack Mounted DevicesRack Mounting Furniture MountingFigure 54. Rack Mounting the DVS Figure 55. Furniture Mounting the DVSExtron Warranty USA, Canada, South Americaand Central America Japan

Related manuals

Manual 4 pages 24.4 Kb