Extron electronic DVS 605 Video effect, Effect duration, HDCP notification green screen/message

Page 58
Video effect

Command

ASCII Command

Response

Additional Description

 

(host to scaler)

(scaler to host)

 

 

 

 

 

 

 

 

 

Video effect

 

 

 

Cut

E0SWEF}

Swef0]

Sets the switch to cut.

Dissolve

E1SWEF}

Swef1]

Sets the switch to dissolve.

View setting

ESWEF}

0] (or 1])

View setting (0 = cut, 1 = dissolve).

 

 

 

 

Effect duration

 

 

 

Set dissolve duration

EX3%EDUR}

EDURX3%]

Sets the effect duration to tenths of seconds

 

 

 

(range 2 = 0.2 to 50 = 05.0 seconds. Default

 

 

 

is 3 = 0.3 seconds).

View duration

EEDUR}

X3%]

View effect duration.

 

 

 

Front panel security lockout (Executive Mode)

 

 

Enable Executive

1X

Exe1]

Lock entire front panel.

mode 1

 

 

 

Enable Executive

2X

Exe2]

Limited front panel adjustments (input

mode 2

 

 

selection, PIP/Swap, and Auto- Image) can

 

 

 

be made.

Disable Executive

0X

Exe0]

Unlock front panel controls. All front panel

mode

 

 

adjustments can be made.

View Executive

X

0] (or) 1]

View the current status:

mode status

 

(or) 2]

0 = off [default]; 1 = on, complete;

 

 

 

2 = on, limited adjustments.

Overscan mode (applies only to SMPTE [NTSC, PAL, 480p, 576p, 720p, 1080i, 1080p] input rates)

Set value

EX#*X2*OSCN}

OscnX#*X2*]

Set input format X# to overscan mode X2*.

View status

EX#OSCN}

X2*]

Show overscan mode status for input

 

 

 

format X#.

 

 

 

HDCP notification (green screen/message)

 

 

Enable notification

EN1HDCP}

HdcpN1]

Enable the HDCP notification.

Disable notification

EN0HDCP}

HdcpN0]

Disable the HDCP notification; instead

 

 

 

mute output.

Query notification

ENHDCP}

X(]

Query the HDCP notification.

HDCP status (valid for HDMI inputs and HDMI oututs only)

Query input

EIX!HDCP}

X3#]

Query the HDCP status of the current input

 

 

 

X!.

 

 

HdcpIX!*X3#]

Verbose mode response

Query output

EOX@HDCP}

X3#]

Query the HDCP status of the HDMI output

 

 

 

X@.

 

 

HdcpOX@*X3#]

Verbose mode response

Effect duration NOTE: X! = Input selection: 1 to 5

X@ = Output selection: 0 = all outputs (default), 1 = analog (VGA, YUVp, HDTV), 2 = HDMI, 3 = 3G/HD-SDI, 4 = none

X# = Input video format: 0 = no signal detected, 1 = RGB, 2 = YUV auto, 3 = RGBcvS, 4 = S-video, 5 = composite,

6 = DVI/HDMI (only available for inputs 3, 4, and 5), 7 = Autodetect (default for inputs 1 and 2)

X( = Enable/disable: 0 = off/disable, 1 = on/enable

X2* = Overscan (applied to SMPTE [NTSC/PAL - 480p -1080p] input rates), 0 = 0.0% (default for RGB/HDMI),

1 = 2.5% (default for YUV, RGBcvS, S-video composite). See X2* on page 37 for details.

X3# = HDCP status (valid only on HDMI/DVI outputs): 0 = no sink or source detected, 1 = sink or source detected with HDCP,

2 = sink or source detected but no HDCP is present

X3% = Effect duration: from 2 to 50, in 0.1 second steps (where 2 = 0.2 seconds, 50 = 5.0 seconds), default = 3 (0.3 seconds)

DVS 605 • SIS Communication and Control

52

Image 58
Contents User Guide SCALERS AND SIGNAL PROCESSORSwith Seamless Switching HDCP-CompliantScalerChinese Simplified(简体中文) Safety InstructionsSafety Instructions • English Instructions de sécurité • FrançaisCopyright FCC Class A NoticeTrademarks Conventions Used in this Guide Specifications AvailabilitySoftware Commands NotificationsUsing the Default Web Pages ContentsSIS Communication and Control Mounting the DVS Introduction DVS 605 Series DescriptionPackage Licensed Third-partySoftware Used in the DVSLicensed Third-partySoftware Used in the DVS LicenseVideo Inputs Key FeaturesVideo Outputs General AudioDVS 605 • Introduction DVS 605 • Introduction Controlling the DVS Rear Panel Cabling DVS 605 Rear Panel Features — All ModelsRear Panel Connections FigureDVS using the LockIt bracket as follows Figure 2. LockIt Bracket Mounting Options Audio Input Connector WiringFigure Figure 5. Audio Output Connector Wiring Figure 4. Audio Output Connector WiringFigure 6. RJ-45LAN Connector Wiring DVS 605 • Rear Panel Connections Figure 7. DVS 605 Front Panel Features •Front Panel Overview •Powering Up•Other DVS 605 Operating Features OperationMenu Navigation Using Front Panel Controls Powering UpDefault Display Cycle Figure 8. Typical Default Display CycleMenu Overview Figure 9. Top Level MenusFigure 10. Main Menu DVS 605 • OperationPicture Control User PresetsFigure 11. User Preset Menu Figure 12. Picture Control MenuInput video types Input ConfigurationFigure 13. Input Configuration Menu InputResolutions and Refresh Rates Output ConfigurationFigure 14. Output Configuration Menu HDMI Format Analog Output FormatSync Polarity HDCP NotificationHDCP Authorized HDCP Status: Inputs & OutputsGenlock/AFL Modes Genlock/AFL Offset Description Audio Delay Setting Audio Configuration All ModelsFigure 17. Audio Configuration Menu Figure 18. Advanced Configuration Menu Advanced ConfigurationAspect Ratio Auto-Image Auto-Imagethreshold settingsAuto Memory Test pattern Switch typeOverscan OSD durationFigure 21. Edit Comm Settings Menu View Comm SettingsFactory Reset Exit MenuEnable Executive Mode Front Panel Lockout Executive ModesFigure 22. Front Panel Lockout Disable Executive ModeWindow vs. Image Size Position — An Overview DVS 605 OperationFront Panel Activation Picture-in-picturePIP ModeNOTES PIP Presets Figure 24. Default Main and PIP Window LayoutsCustom EDID/Custom Output Resolution Other DVS 605 Operating FeaturesPower Save Screen SaveAudio Format Hardwired IR PortThe OSD Bug Audio SourceFigure 25. Reset Mode Comparison Resetting the UnitDVS 605 Reset Mode Summary Reset All IP Reset to Factory Defaults Settings•Commands and Responses SIS Communication and ControlCopyright Information Host to Scaler CommunicationsError Responses Commands and ResponsesPassword Information Error Response ReferencesSymbol Definitions DVS 605 • SIS Communication and ControlFigure 29. SIS Command EDID Table DVS 605 SIS Communication and ControlDVS 605 SIS Communication and Control DVS 605 • SIS Communication and Control SIS IP command definitions DVS 605 • SIS Communication and ControlDVS 605 • SIS Communication and Control ASCII Command SIS Command and Response TableCommand ResponseAuto-Image Additional DescriptionInput name Horizontal startResponse CommandASCII Command Additional DescriptionColor Picture AdjustmentsVideo mute TintHorizontal position image Horizontal position windowVertical position window Vertical position imageHorizontal size image Output ConfigurationPower save mode Output scaler rateAudio delay available on all models Audio Configuration Audio mute global settingsVolume control audio models only CommandAudio follow Audio input formatAudio output format CommandInput presets Presets User presetsUser preset name Input preset nameFreeze Advanced ConfigurationTest pattern Auto memories per inputFront panel security lockout Executive Mode Video effectEffect duration HDCP notification green screen/messageGenlock/AFL Offset Video signal presenceGenlock CommandPicture In Picture Hardwired IR portReset commands PIP on/offProduct naming Backup/restore configurationInformation request CommandCommand Ethernet data portFirmware version requests ASCII TelnetCommand IP setup commandsInformation requests ASCII TelnetNOTE: E X12!CA Re-mapport designations Directory commandsFile erase commands Command•Accessing the Default Web Pages Using the Default Web PagesAccessing the Default Web Pages Navigating the Default Web PagesTo check compatibility view settings Navigating the Default Web PagesTurning Off Compatibility Mode Auto-Imagebutton Configuration PagesAV Controls Panel AV input buttons inputsVideo and audio mute buttons Breakaway audio check box audio models onlyFreeze button Input renaming Signal typeFigure 34. Input Configuration Panel RGB ScaledAuto-Image Aspect ratioFilm Detect Auto MemoryFigure 35. Input Configuration Panel ResolutionAnalog signal format Refresh rateGenlock Digital output signal formatSwitch transition Test patternEDID Minder Page Figure 36. EDID Minder PageAssigning EDIDs Figure 37. Assigning EDIDsSignal Sampling Image Settings PageFigure 38. Image Settings Page Setting User PresetsSettings Included Within Presets User PresetInput Presets OverscanPIP input selection PIP Settings PageFigure 40. PIP Settings Page Snap PIP toHorizontal Size and Vertical Size fields PIP picture controlsSize and Position Horizontal Pos and Vertical Pos fieldsPIP presets Figure 41. PIP Preset Default Window LocationsNone Audio Settings PageFigure 42. Audio Config Page •2-CHDigital •Full DigitalDual Mono Stereoa.Recall: Inputs, Size & Position, or Preset Management PageFigure 43. Preset Management Page b.Recall: Size & Position OnlyDevice Settings Page Figure 44. Device Settings PageOn Screen Display Message Screen Saver Settings1.Select the Enable On Screen Display check box HDCP NotificationAuto Switch Figure 46. Unit Information Page Hardware PagesUnit Information Page See Licensed Third-partySoftware Used in theDevice Name Page Connection Settings PageFigure 48. Connection Settings Page Figure 47. Device Name PageFirmware Loader Page RS-232SettingsEthernet Settings Figure 49. Firmware Loader PageFigure 50. Executive/Power Mode Page Executive/Power Mode PageExecutive Mode Mute Video and Sync Power ModeDate and Time Page Figure 51. Date and Time PagePassword Page Figure 52. Password PageFigure 53. Reset Device Page Reset Device Pagedevice name, DHCP setting, and port mapping Mounting the DVS Tabletop PlacementMounting UL Guidelines for Rack Mounted DevicesFigure 54. Rack Mounting the DVS Rack MountingFurniture Mounting Figure 55. Furniture Mounting the DVSand Central America Extron WarrantyUSA, Canada, South America Japan
Related manuals
Manual 4 pages 24.4 Kb