5.Attach the copper tubing to the refrigerator with a “P” clamp. Slide the plastic waterline into the retainer.
A
B
C
A.“P” Clamp | C. Compression sleeve |
B. Brass nut |
|
6.Turn on water supply to refrigerator and check for leaks. Correct any leaks.
Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
1.Plug into a grounded 3 prong outlet.
2.Flush the water system. See “Water and Ice Dispenser.”
NOTE: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill the ice container.
Refrigerator Doors and Drawer
All graphics referenced in the following instructions are included later in this section after “Final Steps.”
Remove and Replace Handles
Style 1 - Metal Handles
1.Using a ³⁄₃₂" Allen wrench, loosen the two set screws located on the side of each handle. See Metal Handle graphics 1 and 2.
2.Pull the handle straight out from the door. Make sure you keep the screws for reattaching the handles.
3.To replace the handles, reverse the directions.
Style 2 - Plastic Handles
To Remove Handles:
1.Grasp the lower part of the handle firmly, slide the handle up and pull the handle straight out from the door. See Plastic Handle graphics 1 and 2.
To Replace Handles:
1.Position the handle so that the large holes in the mounting clips are down and align the holes with the door studs.
2.Rotate the handle so that the mounting clips are flat against the door and slide the handle down to engage. See Plastic Handle graphics 1 and 2.
Remove Doors and Hinges
IMPORTANT:
■Remove food and any adjustable door or utility bins from doors.
■Keep the refrigerator doors closed until you are ready to lift them free from the cabinet.
NOTE: Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working.
TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄"
1.Unplug refrigerator or disconnect power.
2.Remove the base grille. Grasp the grille firmly and pull it toward you.
5