GE 200D2600P010 Inserting the door panels, Insert the Freezer Panel and Fresh Food Panel

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions

Inserting the door panels.

Read these instructions completely and carefully.

Loosen the Top Trim on the Freezer and Fresh Food Doors.

Using a T-20 Torx driver, loosen the two screws attaching the Top Trim about 1/4″ (6 mm).

Insert the Freezer Panel and Fresh Food Panel.

Lift the Top Trim up 1/4″ (6 mm) and carefully	If your model has a dispenser and/or a
push the freezer panel in until it slides into the slot	Refreshment Center, this step only applies
behind the door handle. Push the filler panel	to the top panels.
(required with some door panels) in behind the
decorator panel. Repeat for fresh food panel.

Insert the Bottom Panel.

Carefully push the panel in until it slides into the slot behind the door handle. Push the filler panel (required with some door panels) in behind the decorator panel.

Hand tighten the two screws on the Top Trim.

Cut-Out

Top Trim Screws

Cut-Out

Top

Freezer

Panel

Fresh

Food

Panel

Tape Liner

Bottom

Freezer

Panel

Side Trim

Side Trim

20