Cleveland Range HA-MKGL-80-CC-T, HA-MKGL-100-CC manual Care and Cleaning, Cleaning Instructions

Page 10

CLEANING INSTRUCTIONS

CAUTION

SURFACES MAY

BE EXTREMELY HOT!

CARE AND CLEANING

Cooking equipment must be cleaned regularly to maintain its fast, efficient cooking performance and to ensure its continued safe, reliable operation. The best time to clean is shortly after each use (allow unit to cool to a safe temperature).

WARNINGS

Do not use detergents or

 

cleansers that are chloride

 

based or contain quaternary

 

salt.

 

Chloride Cleaners

Do not use a metal bristle

 

brush or scraper.

 

Wire Brush &

Steel wool should never be

 

used for cleaning the stainless

 

steel.

 

Steel Pads

Unit should never be cleaned

 

with a high pressure spray

 

hose.

 

High Pressure

 

Spray Hose

Do not leave water sitting in unit

 

when not in use.

CLEANING INSTRUCTIONS

1.Turn unit off.

2.Remove drain screen (if applicable). Thoroughly wash and rinse the screen either in a sink or a dishwasher.

3.Prepare a warm water and mild detergent solution in the unit.

4.Remove food soil using a nylon brush.

5.Loosen food which is stuck by allowing it to soak at a low temperature setting.

6.Drain unit.

7.Rinse interior thoroughly.

8.If the unit is equipped with a Tangent Draw-Off Valve, clean as follows:

a)Disassemble the draw-off valve first by turning the valve knob counter-clockwise, then turning the large hex nut counter-clockwise until the valve stem is free of the valve body.

b)In a sink, wash and rinse the inside of the valve body using a nylon brush.

c)Use a nylon brush to clean tangent draw-off tube.

d)Rinse with fresh water.

e)Reassemble the draw-off valve by reversing the procedure for disassembly. The valve's hex nut should be hand tight only.

9.If the unit is equipped with a Butterfly Valve, clean as follows:

a)Place valve in open position.

b)Wash using a warm water and mild detergent solution.

c)Remove food deposits using a nylon brush.

d)Rinse with fresh water.

e)Leave valve open when unit is not in use.

10.Using mild soapy water and a damp sponge, wash the exterior, rinse, and dry.

NOTES

For more difficult cleaning applications one of the following can be used: alcohol, baking soda, vinegar, or a solution of ammonia in water.

Leave the cover off when the kettle is not in use.

For more detailed instructions refer to the Nafem Stainless Steel Equipment Care and Cleaning manual (supplied with unit).

Stagnant

Water

Image 10
Contents Cleveland For the User Retain this Manual for Your ReferenceFor your safety Inspection GeneralVentilation Shipping Damage InstructionsGAS CleaningWarranty ElectricalSpecification Drawing Stationary Models 100 GAL Specification Drawing Tilting Models Solid Foot DetailOperating Instructions General Care and Cleaning Cleaning InstructionsStainless Steel Equipment Care and Cleaning Product Valve Scraper BladesAgitator Bushing AgitatorQuad Ring Scraper Blades Agitator Seal AssemblyOperating Controls Pressure Relief Assembly Sight GlassHinge Assembly Item no Description QTYWater Meter Assembly Flush Piston Valve Used Prior to Flush Piston Valve Temperature Sensor Assemblies Includes Parts 5Gearmotor Electrical Assembly Kettle Electrical Components Item ON. Part NO. Description QTYKettle GAS Components GAS Orifice Control BOX Electrical Item on Description Control BOX Water Meter & Chart Recorder IndexSide BOX Pneumatics Side BOX Tilt Mechanism Switches Item no Description QTYSocket HD. CAP Screw Maintenance Operating Sequence Heating Kettle Safety Inspection Checklist Safety Thermostat Quad Ring Replacement Procedure AIR Filter Replacement ProcedureNEW Scraper Blade Installation Procedure Lubrication ProcedureOIL Filling Procedure Bushing Replacement ProcedureHinge Adjustment Repairing Leaks in Steam Jacketed Kettle Fittings Vacuum Leak Test ProcedureKettle Venting Reservoir Fill Procedures Kettle Jacket will Result in Irreversible Damage to UnitPressure Relief Valve Periodic Testing Calibrating ProcedureKettle Jacket Filling & Draining Procedures Recommended Corrosion Inhibitors for Closed SystemsHA Drive Shaft Replacement Procedure Page Field Conversion Instructions Natural Gas to Propane Gas Spare Parts List Part Number Description QuantityAC Inverter Programming Instructions Program Code SummarySTR Wiring Diagram Dual Remote Wiring Diagram Single Remote