Cleveland Range HA-MKGL-60-T, HA-MKGL-100-CC For the User, Retain this Manual for Your Reference

Page 2

FOR THE USER

IMPORTANT!

ENSURE KETTLE IS AT ROOM TEMPERATURE AND

PRESSURE GAUGE IS SHOWING ZERO OR LESS PRESSURE

PRIOR TO REMOVING ANY FITTINGS.

FOR YOUR SAFETY

DO NOT STORE OR USE GASOLINE

OR ANY OTHER

FLAMMABLE LIQUIDS AND

VAPOURS IN THE VICINITY

OF THIS OR ANY OTHER

APPLIANCE.

.

WARNING: Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation and operating instructions thoroughly before installing or servicing this equipment.

IMPORTANT

The following points are to insure the safe installation and operation of this equipment:

Insure all gas and electrical supplies match rating plate and electrical stickers.

Observe all clearance requirements.

Disconnect the electrical power supply to the appliance before cleaning or servicing unit.

All service must be performed by a qualified Cleveland Range Technician.

Do not obstruct the flow of combustion and ventilation air.

The installation and connection must comply with current local codes, or in the absence of local codes, with CAN/CGA-B149.1 and .2 installation code or with the national fuel gas code, ANSI Z223.1-L988.

Post in a prominent location, instructions to be followed in the event the user smells gas. This information shall be obtained by consulting your local gas supplier.

The appliance and its individual shut off valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig. (3.45 kpa).

The appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig. (3.45 kpa).

RETAIN THIS MANUAL FOR YOUR REFERENCE.

Image 2
Contents Cleveland For the User Retain this Manual for Your ReferenceFor your safety Inspection GeneralVentilation Shipping Damage InstructionsGAS CleaningWarranty ElectricalSpecification Drawing Stationary Models 100 GALSpecification Drawing Tilting Models Solid Foot DetailOperating Instructions General Care and Cleaning Cleaning InstructionsStainless Steel Equipment Care and Cleaning Product Valve Scraper BladesQuad Ring AgitatorAgitator Bushing Operating Controls Agitator Seal AssemblyScraper Blades Pressure Relief Assembly Sight GlassHinge Assembly Item no Description QTYWater Meter Assembly Flush Piston Valve Used Prior to Flush Piston Valve Temperature Sensor Assemblies Includes Parts 5Gearmotor Electrical Assembly Kettle Electrical Components Item ON. Part NO. Description QTYKettle GAS Components GAS Orifice Control BOX Electrical Item on Description Control BOX Water Meter & Chart Recorder IndexSide BOX Pneumatics Side BOX Tilt Mechanism Switches Item no Description QTYSocket HD. CAP Screw Maintenance Operating Sequence Heating Kettle Safety Inspection Checklist Safety Thermostat Quad Ring Replacement Procedure AIR Filter Replacement ProcedureNEW Scraper Blade Installation Procedure Lubrication ProcedureHinge Adjustment Bushing Replacement ProcedureOIL Filling Procedure Kettle Venting Vacuum Leak Test ProcedureRepairing Leaks in Steam Jacketed Kettle Fittings Reservoir Fill Procedures Kettle Jacket will Result in Irreversible Damage to UnitPressure Relief Valve Periodic Testing Calibrating ProcedureKettle Jacket Filling & Draining Procedures Recommended Corrosion Inhibitors for Closed SystemsHA Drive Shaft Replacement Procedure Page Field Conversion Instructions Natural Gas to Propane Gas Spare Parts List Part Number Description QuantityAC Inverter Programming Instructions Program Code SummarySTR Wiring Diagram Dual Remote Wiring Diagram Single Remote