LG Electronics 800 Roasting With Convection, Roasting Notes, To set Convect Roast, Oven Cooking

Page 11

Roasting With Convection

Roasting Notes: Oven Cooking

Roasting With Convection

(select models)

When convection roasting, enter your normal roasting time and temperature. The control will automatically prompt you to check the food for doneness at 75% of the set time. The convection fan will start after the oven has been on for five minutes.

4.Press Convect Roast pad again or wait four seconds.

•ROAST will stop flashing and light in the display.

•100° or the actual oven temperature will display. It will rise in 5° increments until the preset temperature is reached.

•The FAN icon will start to rotate.

Roasting Notes:

•When convection roasting, the cooking time must be set before setting the temperature.

•If your recipe requires a preheated oven, add 15 minutes to the cooking time programmed.

•Roasting times can vary with different cuts of meat.

•It is not necessary to preheat when convect roasting large cuts of meat.

•Refer to “Cooking Made Simple” booklet for suggested roasting temperatures and times.

To set Convect Roast:

1. Press the Convect Roast pad.

•ROAST and the FAN icon will flash.

•00:00 will flash in the display.

•000 lights in the display.

2.Enter the roasting time using the number pads.

•Time can be set from 10 minutes (00:10) to 11 hours, 59 minutes (11:59).

•Press Convect Roast pad again or wait 4 seconds.

•ROAST and the FAN icon flash in the display.

•000 will flash in the display.

3.Select the oven temperature. Press the Autoset 0 pad for 325° F or the appropriate number pads.

•Each additional press of the Autoset 0 pad will increase the temperature by 25°.

•The oven temperature can be set from 170° to 550°.

Notes:

•If a preheat is required, allow the oven to preheat for 8-15 minutes.

•When the set oven temperature is reached, one long beep will sound.

5.Place food in the oven.

•Time will start counting down once oven starts heating up.

•To recall the set temperature during preheat, press the Convect Roast pad.

6.When 75% of the set cooking time has elapsed, the oven light will turn on and FOOD will flash in the display. Check the cooking progress at this time. Cook longer if needed.

•The oven light will remain on until the Oven Light pad is pressed.

•Press any pad to recall the cook time remaining.

7.When cooking is finished, press CANCEL pad.

8. Remove food from the oven.

10

Image 11

Contents Maintenance Table of ContentsImportant Safety Care & CleaningGeneral Instructions Important SafetyRecognize Safety Symbols, Words, Labels InstructionsIn Case of Fire Important Safety InstructionsChild Safety To Prevent Fire or Smoke DamageUtensil Safety Cooking SafetySave These Instructions for Future Reference Cleaning SafetySelf-CleanOven Important Safety Notice and WarningSurface Controls Operating During a Power FailureSetting the controls Surface CookingBurner Grates Surface CookingCooktop Sealed BurnersClock Using the TouchpadsOven Cooking Control PanelTo restore the Clock display TimerFault Codes To cancel the Clock displayBaking Differences Between Your Old and New Oven BakingBaking with Convection Baking NotesTo set Convect Roast Roasting With ConvectionRoasting Notes Delay Cook & Hold When the cooking time has elapsedTo cancel Cook & Hold at any time Cook & HoldTo set Broil Broiling ChartBroiling Broil NotesTo set Keep Warm To cancel Keep WarmKeep Warm Keep Warm NotesSabbath Mode Notes To cancel the Sabbath ModeAutomatic Shut-Off/SabbathMode Changing Temp F/C Adjusting the Oven TemperatureTo adjust the oven temperature To cancel a Favorite cycle in progressOven Light Oven FanOven Vent Oven RacksBaking Layer Cakes on Two Racks Create-A-SpaceTM Half RackTo Delay a Self-CleanCycle Care & CleaningBefore Self-Cleaning To set Self-CleanSounds During the Self-CleanCycleAfter Self-Cleaning Smoke and SmellsPART Care & CleaningCleaning Procedures PROCEDUREPART Leveling Legs MaintenanceOven Door Oven WindowStorage Drawer Removal of Gas ApplianceSOLUTION TroubleshootingPROBLEM SOLUTION Notes Full One Year Warranty - Parts and Labor Warranty & ServiceWhat is Not Covered By These Warranties If You Need ServiceInstructions de sécurité Guide d’utilisation et d’entretienCuisinière à gaz à touches de précision Table des matièresInstructions de sécurité importantes AVERTISSEMENTSécurité pour les enfants Instructions de sécurité importantesInstructions générales En cas d’incendieCuisson et sécurité Familiarisation avec l’appareilNettoyage et sécurité Ustensiles et sécuritéAvertissement et avis important pour la sécurité Four autonettoyantCuisson sur la surface Commandes de la surface de cuissonBoutons de commande de la surface de cuisson Réglage des commandesBrûleur de mijotage Surface de cuissonBrûleurs scellés Brûleurs de haute performanceHorloge Tableau de commandeCuisson dans le four Utilisation des touchesRéglage de l’horloge Verrouillage des commandes et de la porte du fourCuisson dans le four MinuterieCuisson avec convection Cuisson dans le fourCodes d’anomalie Cuisson couranteProgrammation du rôtissage avec convection Rôtissage avec convectionRemarques sur le rôtissage Lorsque la durée de cuisson s’est écoulée Cuisson et maintienCuisson et maintien différés Programmation de Cuisson et maintienAnnulation du maintien au chaud Maintien au chaudRemarques sur la fonction de maintien au chaud Programmation du Maintien au chaudProgrammation de la cuisson au gril Cuisson au grilRemarques sur la cuisson au gril Tableau de cuisson au grilAnnulation du mode sabbat Arrêt automatique/Mode sabbatRemarques sur le mode sabbat Ajustement de la température du four Ajustement de la température du fourChangement de la température F/C FavoriÉvent du four RéinstallationAllumage sans flamme de veille Ventilateur du fourCuisson de gâteaux à étages sur deux grilles Demi-grille Create-A-SpaceTMDémarrage différé d’un cycle d’autonettoyage NettoyageAvant l’autonettoyage Programmation de l’autonettoyageBruits Après le cycle d’autonettoyagePendant le cycle d’autonettoyage Fumée et odeursNETTOYAGE Méthodes de nettoyagePIÈCE NETTOYAGE Raccordement électrique EntretienPorte du four Hublot du fourDépose Déplacement d’un appareil à gazTiroir de remisage PROBLÈME Recherche des pannesPROBLÈME Résidents canadiens Garantie et service après-venteNe sont pas couverts par ces garanties Si l’intervention d’un réparateur est nécessaireTabla de Materias Guía de Uso y CuidadoEstufa a Gas con Control a Precisión Sensible al TactoPRECAUCIÓN InstruccionesSeguridad ADVERTENCIASeguridad para los Niños Instrucciones Importantes sobre SeguridadInstrucciones Generales En Caso de IncendioSeguridad Para Cocinar GeneralidadesHorno Autolimpiante Utensilios ApropiadosSeguridad de la Limpieza Aviso y Advertencia Importante Sobre Seguridad Perillas de Control de los Elementos Superiores Cocinando en la EstufaControles Superiores Encendido Sin PilotoQuemador para Cocinar a Fuego Lento CubiertaQuemadores Sellados Quemadores de Alto Rendimiento‘Clock’ Reloj Cocinando en el HornoPanel de Control Uso de las TeclasPara cancelar el temporizador Códigos de Errores‘Timer’ Temporizador Para cancelar el despliegue del relojmodelos selectos HorneadoHorneado por Convección Notas sobre HorneadoPara programar ‘Cook & Hold’ Asado por Convección‘Cook & Hold’ Notas sobre AsadoCuando haya expirado el tiempo de cocción Para cancelar ‘Cook & Hold’ en cualquier momento‘Delay Cook & Hold’ ‘Cook & Hold’ DiferidoPara programar ‘Broil’ ‘Broiling’ Asar a la ParrillaNotas Sobre Asado a la Parrilla Tabla de Asar a la ParrillaPara programar ‘Keep Warm’ Para cancelar ‘Keep Warm’‘Keep Warm’ Mantener Caliente Notas sobre ‘Keep Warm’72 horas Para cancelar el Modo SabáticoCierre Automático/Modo Sabático Notas Sobre el Modo Sabático‘Favorite’ Favorito Para cancelar un ciclo favorito en progresoAjuste de la temperatura del horno Cambio de la temperatura de F/CRespiradero del Horno Encendido sin PilotoVentilador del horno Parrillas del HornoHorneado de Pasteles de Capas en Dos Parrillas Media Parrilla Create-A-SpaceMRPara diferir un ciclo de autolimpieza Para programar ‘Self-Clean’AutolimpiezaCuidado y Limpieza Antes de la AutolimpiezaSonidos Durante el ciclo de autolimpiezaDespués del ciclo de autolimpieza Humo y OloresPROCEDIMIENTO DE LIMPIEZA Cuidado y LimpiezaProcedimientos de Limpieza PIEZACuidado y Limpieza Tornillos Niveladores MantenimientoPuerta del Horno Ventana del HornoPara volver a colocar Retiro de la Estufa a GasGaveta de Almacenamiento Para sacarSOLUCION PROBLEMALocalización y Solución de Averías SOLUCION Residentes Canadienses Garantía y ServicioLo que No Cubren Estas Garantías Si Necesita Servicio