LG Electronics 800 Maintenance, Oven Door, Oven Window, Leveling Legs, Electrical Connection

Page 23

Maintenance

Maintenance

Oven Door

CAUTION

Do not place excessive weight on or stand on an open oven door. This could cause the range to tip over, break the door, or injure the user.

Note: The oven door on a new range may feel “spongy” when it is closed. This is normal and will decrease with use.

Oven Window

To protect the oven door window:

1.Do not use abrasive cleaning agents such as steel wool scouring pads or powdered cleansers as they may scratch the glass.

2.Do not hit the glass with pots, pans, furniture, toys, or other objects.

3.Do not close the oven door until the oven racks are in place.

Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later date.

Leveling Legs

CAUTION

Be sure the anti-tip bracket secures one of the rear leveling legs to the floor. This bracket prevents the range from accidentally tipping.

The range should be leveled when installed. If the range is not level, turn the plastic leveling legs, located at each corner of the range, until range is level.

ANTI-TIP BRACKET

LEVELING LEG

Electrical Connection

Appliances which require electrical power

are equipped with a three-prong grounding plug which must be plugged directly into a properly grounded three- hole 120 volt electrical outlet.

Always disconnect power to appliance before servicing.

The three-prong grounding plug offers protection against shock hazards. DO NOT CUT OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD PLUG.

If an ungrounded, two-hole or other type electrical outlet is encountered, it is the personal responsibility of the appliance owner to have the outlet replaced with a properly grounded three-hole electrical outlet.

Oven Light

CAUTION

•Disconnect power to range before replacing light bulb.

•Allow oven to cool before replacing light bulb.

•Make sure bulb cover and bulb are cool before touching.

To replace oven light bulb:

1.	When oven is cool, hold bulb cover	BULB COVER
1.	When oven is cool, hold bulb cover
	in place, then slide wire retainer
	off cover. NOTE: Bulb cover
	will fall if not held in place
	while removing wire retainer.
2.	Remove bulb cover and light	WIRE

bulb.	RETAINER

3.Replace with a 40-watt appliance bulb.

4.Replace bulb cover and secure with wire retainer.

5.Reconnect power to range. Reset clock.

22

Image 23

Contents Maintenance Table of ContentsImportant Safety Care & CleaningGeneral Instructions Important SafetyRecognize Safety Symbols, Words, Labels InstructionsIn Case of Fire Important Safety InstructionsChild Safety To Prevent Fire or Smoke DamageUtensil Safety Cooking SafetySave These Instructions for Future Reference Cleaning SafetySelf-CleanOven Important Safety Notice and WarningSurface Controls Operating During a Power FailureSetting the controls Surface CookingBurner Grates Surface CookingCooktop Sealed BurnersClock Using the TouchpadsOven Cooking Control PanelTo restore the Clock display TimerFault Codes To cancel the Clock displayBaking Differences Between Your Old and New Oven BakingBaking with Convection Baking NotesTo set Convect Roast Roasting With ConvectionRoasting Notes Delay Cook & Hold When the cooking time has elapsedTo cancel Cook & Hold at any time Cook & HoldTo set Broil Broiling ChartBroiling Broil NotesTo set Keep Warm To cancel Keep WarmKeep Warm Keep Warm NotesSabbath Mode Notes To cancel the Sabbath ModeAutomatic Shut-Off/SabbathMode Changing Temp F/C Adjusting the Oven TemperatureTo adjust the oven temperature To cancel a Favorite cycle in progressOven Light Oven FanOven Vent Oven RacksBaking Layer Cakes on Two Racks Create-A-SpaceTM Half RackTo Delay a Self-CleanCycle Care & CleaningBefore Self-Cleaning To set Self-CleanSounds During the Self-CleanCycleAfter Self-Cleaning Smoke and SmellsPART Care & CleaningCleaning Procedures PROCEDUREPART Leveling Legs MaintenanceOven Door Oven WindowStorage Drawer Removal of Gas ApplianceSOLUTION TroubleshootingPROBLEM SOLUTION Notes Full One Year Warranty - Parts and Labor Warranty & ServiceWhat is Not Covered By These Warranties If You Need ServiceInstructions de sécurité Guide d’utilisation et d’entretienCuisinière à gaz à touches de précision Table des matièresInstructions de sécurité importantes AVERTISSEMENTSécurité pour les enfants Instructions de sécurité importantesInstructions générales En cas d’incendieCuisson et sécurité Familiarisation avec l’appareilNettoyage et sécurité Ustensiles et sécuritéAvertissement et avis important pour la sécurité Four autonettoyantCuisson sur la surface Commandes de la surface de cuissonBoutons de commande de la surface de cuisson Réglage des commandesBrûleur de mijotage Surface de cuissonBrûleurs scellés Brûleurs de haute performanceHorloge Tableau de commandeCuisson dans le four Utilisation des touchesRéglage de l’horloge Verrouillage des commandes et de la porte du fourCuisson dans le four MinuterieCuisson avec convection Cuisson dans le fourCodes d’anomalie Cuisson couranteProgrammation du rôtissage avec convection Rôtissage avec convectionRemarques sur le rôtissage Lorsque la durée de cuisson s’est écoulée Cuisson et maintienCuisson et maintien différés Programmation de Cuisson et maintienAnnulation du maintien au chaud Maintien au chaudRemarques sur la fonction de maintien au chaud Programmation du Maintien au chaudProgrammation de la cuisson au gril Cuisson au grilRemarques sur la cuisson au gril Tableau de cuisson au grilAnnulation du mode sabbat Arrêt automatique/Mode sabbatRemarques sur le mode sabbat Ajustement de la température du four Ajustement de la température du fourChangement de la température F/C FavoriÉvent du four RéinstallationAllumage sans flamme de veille Ventilateur du fourCuisson de gâteaux à étages sur deux grilles Demi-grille Create-A-SpaceTMDémarrage différé d’un cycle d’autonettoyage NettoyageAvant l’autonettoyage Programmation de l’autonettoyageBruits Après le cycle d’autonettoyagePendant le cycle d’autonettoyage Fumée et odeursNETTOYAGE Méthodes de nettoyagePIÈCE NETTOYAGE Raccordement électrique EntretienPorte du four Hublot du fourDépose Déplacement d’un appareil à gazTiroir de remisage PROBLÈME Recherche des pannesPROBLÈME Résidents canadiens Garantie et service après-venteNe sont pas couverts par ces garanties Si l’intervention d’un réparateur est nécessaireTabla de Materias Guía de Uso y CuidadoEstufa a Gas con Control a Precisión Sensible al TactoPRECAUCIÓN InstruccionesSeguridad ADVERTENCIASeguridad para los Niños Instrucciones Importantes sobre SeguridadInstrucciones Generales En Caso de IncendioSeguridad Para Cocinar GeneralidadesHorno Autolimpiante Utensilios ApropiadosSeguridad de la Limpieza Aviso y Advertencia Importante Sobre Seguridad Perillas de Control de los Elementos Superiores Cocinando en la EstufaControles Superiores Encendido Sin PilotoQuemador para Cocinar a Fuego Lento CubiertaQuemadores Sellados Quemadores de Alto Rendimiento‘Clock’ Reloj Cocinando en el HornoPanel de Control Uso de las TeclasPara cancelar el temporizador Códigos de Errores‘Timer’ Temporizador Para cancelar el despliegue del relojmodelos selectos HorneadoHorneado por Convección Notas sobre HorneadoPara programar ‘Cook & Hold’ Asado por Convección‘Cook & Hold’ Notas sobre AsadoCuando haya expirado el tiempo de cocción Para cancelar ‘Cook & Hold’ en cualquier momento‘Delay Cook & Hold’ ‘Cook & Hold’ DiferidoPara programar ‘Broil’ ‘Broiling’ Asar a la ParrillaNotas Sobre Asado a la Parrilla Tabla de Asar a la ParrillaPara programar ‘Keep Warm’ Para cancelar ‘Keep Warm’‘Keep Warm’ Mantener Caliente Notas sobre ‘Keep Warm’72 horas Para cancelar el Modo SabáticoCierre Automático/Modo Sabático Notas Sobre el Modo Sabático‘Favorite’ Favorito Para cancelar un ciclo favorito en progresoAjuste de la temperatura del horno Cambio de la temperatura de F/CRespiradero del Horno Encendido sin PilotoVentilador del horno Parrillas del HornoHorneado de Pasteles de Capas en Dos Parrillas Media Parrilla Create-A-SpaceMRPara diferir un ciclo de autolimpieza Para programar ‘Self-Clean’AutolimpiezaCuidado y Limpieza Antes de la AutolimpiezaSonidos Durante el ciclo de autolimpiezaDespués del ciclo de autolimpieza Humo y OloresPROCEDIMIENTO DE LIMPIEZA Cuidado y LimpiezaProcedimientos de Limpieza PIEZACuidado y Limpieza Tornillos Niveladores MantenimientoPuerta del Horno Ventana del HornoPara volver a colocar Retiro de la Estufa a GasGaveta de Almacenamiento Para sacarSOLUCION PROBLEMALocalización y Solución de Averías SOLUCION Residentes Canadienses Garantía y ServicioLo que No Cubren Estas Garantías Si Necesita Servicio