Maytag MGR5875QDW Maintenance, Oven Window, Leveling Legs, Electrical Connection

Page 23

Maintenance

Oven Door

CAUTION

Do not place excessive weight on or stand on an open oven door. This could cause the range to tip over, break the door, or injure the user.

Note: The oven door on a new range may feel “spongy” when it is closed. This is normal and will decrease with use.

Oven Window

To protect the oven door window:

1.Do not use abrasive cleaning agents such as steel wool scouring pads or powdered cleansers as they may scratch the glass.

2.Do not hit the glass with pots, pans, furniture, toys, or other objects.

3.Do not close the oven door until the oven racks are in place.

Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later date.

Leveling Legs

CAUTION

Be sure the anti-tip bracket secures one of the rear leveling legs to the floor. This bracket prevents the range from accidentally tipping.

Be sure the range is leveled when installed. If the range is not level, turn the leveling legs, located at each corner of the range, until range is level.

ANTI-TIP BRACKET

LEVELING LEG

Electrical Connection

Appliances which require electrical power

are equipped with a three-prong grounding plug which must be plugged directly into a properly grounded three- hole 120 volt electrical outlet.

Always disconnect power to appliance before servicing.

The three-prong grounding plug offers protection against shock hazards. DO NOT CUT OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD PLUG.

If an ungrounded, two-hole or other type electrical outlet is encountered, it is the personal responsibility of the appliance owner to have the outlet replaced with a properly grounded three-hole electrical outlet.

Oven Light

CAUTION

Disconnect power to range before replacing light bulb.

Allow oven to cool before replacing light bulb.

Make sure bulb cover and bulb are cool before touching.

To replace oven light bulb:

1.

When oven is cool, hold bulb cover

BULB COVER

 

 

in place, then slide wire retainer

 

 

off cover. Note: Bulb cover

 

 

will fall if not held in place

 

 

while removing wire retainer.

 

2.

Remove bulb cover and light

WIRE

bulb.

RETAINER

 

3.Replace with a 40-watt appliance bulb.

4.Replace bulb cover and secure with wire retainer.

5.Reconnect power to range. Reset clock.

22

Image 23
Contents Gas Precision Touch Control Table of ContentsUse & Care Guide Canada Recognize Safety Symbols, Words, LabelsInstructions General InstructionsCase of Fire Important Safety InstructionsChild Safety To Prevent Fire or Smoke DamageUtensil Safety Cooking SafetySave These Instructions for Future Reference Cleaning SafetySelf-Clean Oven Important Safety Notice and WarningPilotless Ignition Operating During a Power FailureSurface Cooking Surface ControlsBurner Grates Power Boost BurnerCooktop Sealed Gas BurnersClock Using the TouchpadsOven Cooking Control PanelLocking the Control Oven Door TimerFault Codes Baking Differences Between Your Old and New Oven BakingBaking with Convection Baking NotesTo set Convect Roast Roasting With ConvectionRoasting Notes Cook & Hold Delay Cook & HoldRack Total Food Position Broiling ChartBroiling Broil NotesKeep Warm Notes To cancel Keep WarmPress the Cancel pad Remove food from the oven Keep WarmTo cancel the Sabbath Mode Automatic Shut-Off Sabbath ModeSabbath Mode Notes Favorite Adjusting the Oven TemperatureChanging Temp F/C Oven Light Oven FanOven Vent Oven RacksBaking Layer Cakes on Two Racks Create-A-SpaceTMHalf RackTo Delay a Self-Clean Cycle Before Self-CleaningTo set Self-Clean Sounds During the Self-Clean CycleAfter Self-Cleaning Smoke and SmellsPart Procedure Care & CleaningCleaning Procedures Stainless Steel To restore ease of movement, then wipe off excess oilFirst GlassElectrical Connection MaintenanceOven Window Leveling LegsStorage Drawer Removal of Gas ApplianceInches between pans and oven wall TroubleshootingProblem Solution BrowningOff. This is normal Word is not displayedControl and door may be locked. See Page Maytag Major Appliance Warranty Table des matières Cuisinière à gaz à touches de précisionLes instructions de sécurité importantes et les paragraphes Instructions de sécurité importantesSécurité pour les enfants Instructions généralesPour éviter un incendie ou des dommages par la fumée En cas d’incendieCuisson et sécurité Familiarisation avec l’appareilNettoyage et sécurité Ustensiles et sécuritéConserver ces instructions pour consultation ultérieure Four autonettoyantAvertissement et avis important pour la sécurité Cuisson sur la surface Brûleur de mijotage Brûleur de haute performance Power BoostSurface de cuisson Brûleurs à gaz scellésHorloge Tableau de commandeCuisson dans le four Utilisation des touchesMinuterie Verrouillage des commandes et de la porte du fourCuisson avec convection Codes d’anomalieCuisson courante Programmation du rôtissage avec convection Rôtissage avec convectionRemarques sur le rôtissage Cuisson et maintien différés Cuisson et maintienAnnulation du maintien au chaud Maintien au chaudRemarques sur la fonction de maintien au chaud Programmation du Maintien au chaudPosition DES Degré DE Temps DE Aliments Cuisson au grilRemarques sur la cuisson au gril Tableau de cuisson au grilSAb sera affiché et clignotera pendant cinq secondes Arrêt automatique Mode sabbatRemarques sur le mode sabbat Annulation du mode sabbatFavori Ajustement de la température du fourChangement de la température F/C Grilles du four Allumage sans flamme de veilleVentilateur du four Évent du fourToujours libre pour loger une cocotte Demi-grille Create-A-SpaceMCCuisson de gâteaux à étages sur deux grilles Démarrage différé d’un cycle d’autonettoyage NettoyageAvant l’autonettoyage Programmation de l’autonettoyageBruits Après le cycle d’autonettoyagePendant le cycle d’autonettoyage Fumée et odeursPièce Nettoyage Méthodes de nettoyageEt poignées PanneauxLatéraux, tiroir De remisageEntretien Dépose Déplacement d’un appareil à gazTiroir de remisage Recherche des pannes Problème SolutionLa porte du four ne se déverrouille Les commandes et la porte sont peut-être verrouillées. VoirImpossibilité d’autonettoyage Particulièrement les résidus d’aliments acides ou sucrésGarantie DES Gros Appareils Ménagers Maytag Corporation Tabla de Materias Estufa a Gas con Control a Precisión Sensible al TactoCanadá InstruccionesSeguridad Seguridad para los Niños Instrucciones GeneralesPara Evitar un Incendio o Daño Causado por el Humo En Caso de IncendioSeguridad Para Cocinar GeneralidadesHorno Autolimpiante Utensilios ApropiadosSeguridad de la Limpieza Conserve estas Instrucciones para Referencia Futura Aviso y Advertencia Importante Sobre SeguridadPerillas de Control de los Elementos Superiores Cocinando en la EstufaControles Superiores Encendido Sin PilotoQuemador para Cocinar a Fuego Lento Quemador de Alto Rendimiento Power BoostCubierta Quemadores de Gas Sellados‘Clock’ Reloj Cocinando en el HornoPanel de Control Uso de las TeclasBloqueo de los Controles y de la Puerta del Horno Códigos de Errores‘Timer’ Temporizador Modelos selectos HorneadoHorneado por Convección Notas sobre HorneadoMantener Caliente Asado por Convección‘Cook & Hold’ Cocción y Notas sobre AsadoCocción y Mantener Caliente Diferido ‘Delay Cook & Hold’Para programar ‘Broil’ Asado ‘Broiling’ Asar a la ParrillaNotas Sobre Asado a la Parrilla Tabla de Asar a la ParrillaPara programar ‘Keep Warm’ Para cancelar ‘Keep Warm’‘Keep Warm’ Mantener Caliente Notas sobre ‘Keep Warm’Notas Sobre el Modo Sabático Para cancelar el Modo SabáticoCierre Automático Modo Sabático ‘Favorite’ Favorito Ajuste de la temperatura del hornoCambio de la temperatura de F/C Posiciones de la Parrilla Ventilador del hornoParrillas del Horno Respiradero del HornoColoque los pasteles en las parrillas como se muestra Media Parrilla Create-A-SpaceMRHorneado de Pasteles de Capas en Dos Parrillas Dos parrillas Use la posición 3 y 6 o 2 yLimpie el marco del horno, el marco de Para programar ‘Self-Clean’ AutolimpiezaAntes de la Autolimpieza Para diferir un ciclo de autolimpiezaSonidos Después del ciclo de autolimpiezaDurante el ciclo de autolimpieza Humo y OloresPieza Procedimiento DE Limpieza Procedimientos de LimpiezaCuidado y Limpieza Mantenimiento Para volver a colocar Retiro de la Estufa a GasGaveta de Almacenamiento Para sacarLocalización y Solución de Averías Problema SoluciónVerifique si la puerta está cerrada Códigos de ErroresEl horno no se autolimpia PáginasDE Maytag Corporation