Maytag MGR5875QDW Surface Cooking, Surface Controls, Pilotless Ignition, Surface Control Knobs

Page 6

Surface Cooking

LO: Use to simmer foods, keep foods warm and melt chocolate or butter. Some cooking may take place on the LO setting if the pan is covered. It is possible to reduce the heat by rotating the knob toward OFF. Be sure flame is stable.

HI: Use to bring liquid to a boil, or reach pressure in a pressure cooker. Always reduce setting to a lower heat when liquids begin to boil or foods begin to cook.

An intermediate flame size is used to continue cooking. Food will not cook any faster when a higher flame setting is used than needed to maintain a gentle boil. Water boils at the same temperature whether boiling gently or vigorously.

Surface Controls

CAUTION

If flame should go out during a cooking operation, turn the burner off. If a strong gas odor is detected, open a window and wait five minutes before relighting the burner.

Be sure all surface controls are set in the OFF position prior to supplying gas to the range.

NEVER touch cooktop until it has cooled. Expect some parts of the cooktop, especially around the burners, to become warm or hot during cooking. Use potholders to protect hands.

Setting the controls:

The size and type of cookware will affect the heat setting.

1.Place a pan on the burner grate.

The burner flame may lift off or appear separated from the port if a pan is not placed on the grate.

2.Push in and turn the knob counterclockwise to the LITE setting.

A clicking (spark) sound will be heard and the burner will light. (All five ignitors will spark when any surface burner knob is turned to the LITE position.)

3.After the burner lights, turn knob to desired flame size.

The ignitor will continue to spark until the knob is turned past the LITE position.

Pilotless Ignition

Pilotless ignition eliminates the need for a constant standing pilot light. Each surface burner has a spark ignitor. Use care when cleaning around the surface burner.

If the surface burner does not light, check if ignitor is broken, soiled or wet.

Surface Control Knobs

Use to turn on the surface burners. An infinite choice of heat settings is available from LO to HI. At the HI setting a detent or notch may be felt. The knobs can be set on or between any of the settings.

Graphics next to the knob identify which burner the knob controls. For example, the graphic at

right shows the left front burner location.

Operating During a

Power Failure

CAUTION

When lighting the surface burners, be sure all of the controls are in the OFF position. Strike the match first and hold it in position before turning the knob to LITE.

1.Hold a lighted match to the desired surface burner.

2.Push in and turn the control knob slowly to LITE.

3.Adjust the flame to the desired level.

5

Image 6
Contents Table of Contents Use & Care GuideGas Precision Touch Control General Instructions Recognize Safety Symbols, Words, LabelsInstructions CanadaTo Prevent Fire or Smoke Damage Important Safety InstructionsChild Safety Case of FireCooking Safety Utensil SafetyImportant Safety Notice and Warning Cleaning SafetySelf-Clean Oven Save These Instructions for Future ReferenceSurface Controls Operating During a Power FailureSurface Cooking Pilotless IgnitionSealed Gas Burners Power Boost BurnerCooktop Burner GratesControl Panel Using the TouchpadsOven Cooking ClockTimer Fault CodesLocking the Control Oven Door Baking Notes BakingBaking with Convection Baking Differences Between Your Old and New OvenRoasting With Convection Roasting NotesTo set Convect Roast Delay Cook & Hold Cook & HoldBroil Notes Broiling ChartBroiling Rack Total Food PositionKeep Warm To cancel Keep WarmPress the Cancel pad Remove food from the oven Keep Warm NotesAutomatic Shut-Off Sabbath Mode Sabbath Mode NotesTo cancel the Sabbath Mode Adjusting the Oven Temperature Changing Temp F/CFavorite Oven Racks Oven FanOven Vent Oven LightCreate-A-SpaceTMHalf Rack Baking Layer Cakes on Two RacksBefore Self-Cleaning To set Self-CleanTo Delay a Self-Clean Cycle Smoke and Smells During the Self-Clean CycleAfter Self-Cleaning SoundsCare & Cleaning Cleaning ProceduresPart Procedure Glass To restore ease of movement, then wipe off excess oilFirst Stainless SteelLeveling Legs MaintenanceOven Window Electrical ConnectionRemoval of Gas Appliance Storage DrawerBrowning TroubleshootingProblem Solution Inches between pans and oven wallWord is not displayed Control and door may be locked. SeeOff. This is normal Page Maytag Major Appliance Warranty Cuisinière à gaz à touches de précision Table des matièresInstructions de sécurité importantes Les instructions de sécurité importantes et les paragraphesEn cas d’incendie Instructions généralesPour éviter un incendie ou des dommages par la fumée Sécurité pour les enfantsFamiliarisation avec l’appareil Cuisson et sécuritéUstensiles et sécurité Nettoyage et sécuritéFour autonettoyant Avertissement et avis important pour la sécuritéConserver ces instructions pour consultation ultérieure Cuisson sur la surface Brûleurs à gaz scellés Brûleur de haute performance Power BoostSurface de cuisson Brûleur de mijotageUtilisation des touches Tableau de commandeCuisson dans le four HorlogeVerrouillage des commandes et de la porte du four MinuterieCodes d’anomalie Cuisson couranteCuisson avec convection Rôtissage avec convection Remarques sur le rôtissageProgrammation du rôtissage avec convection Cuisson et maintien Cuisson et maintien différésProgrammation du Maintien au chaud Maintien au chaudRemarques sur la fonction de maintien au chaud Annulation du maintien au chaudTableau de cuisson au gril Cuisson au grilRemarques sur la cuisson au gril Position DES Degré DE Temps DE AlimentsAnnulation du mode sabbat Arrêt automatique Mode sabbatRemarques sur le mode sabbat SAb sera affiché et clignotera pendant cinq secondesAjustement de la température du four Changement de la température F/CFavori Évent du four Allumage sans flamme de veilleVentilateur du four Grilles du fourDemi-grille Create-A-SpaceMC Cuisson de gâteaux à étages sur deux grillesToujours libre pour loger une cocotte Programmation de l’autonettoyage NettoyageAvant l’autonettoyage Démarrage différé d’un cycle d’autonettoyageFumée et odeurs Après le cycle d’autonettoyagePendant le cycle d’autonettoyage BruitsMéthodes de nettoyage Pièce NettoyageDe remisage PanneauxLatéraux, tiroir Et poignéesEntretien Déplacement d’un appareil à gaz Tiroir de remisageDépose Problème Solution Recherche des pannesParticulièrement les résidus d’aliments acides ou sucrés Les commandes et la porte sont peut-être verrouillées. VoirImpossibilité d’autonettoyage La porte du four ne se déverrouilleGarantie DES Gros Appareils Ménagers Maytag Corporation Estufa a Gas con Control a Precisión Sensible al Tacto Tabla de MateriasInstrucciones SeguridadCanadá En Caso de Incendio Instrucciones GeneralesPara Evitar un Incendio o Daño Causado por el Humo Seguridad para los NiñosGeneralidades Seguridad Para CocinarUtensilios Apropiados Seguridad de la LimpiezaHorno Autolimpiante Aviso y Advertencia Importante Sobre Seguridad Conserve estas Instrucciones para Referencia FuturaEncendido Sin Piloto Cocinando en la EstufaControles Superiores Perillas de Control de los Elementos SuperioresQuemadores de Gas Sellados Quemador de Alto Rendimiento Power BoostCubierta Quemador para Cocinar a Fuego LentoUso de las Teclas Cocinando en el HornoPanel de Control ‘Clock’ RelojCódigos de Errores ‘Timer’ TemporizadorBloqueo de los Controles y de la Puerta del Horno Notas sobre Horneado HorneadoHorneado por Convección Modelos selectosNotas sobre Asado Asado por Convección‘Cook & Hold’ Cocción y Mantener Caliente‘Delay Cook & Hold’ Cocción y Mantener Caliente DiferidoTabla de Asar a la Parrilla ‘Broiling’ Asar a la ParrillaNotas Sobre Asado a la Parrilla Para programar ‘Broil’ AsadoNotas sobre ‘Keep Warm’ Para cancelar ‘Keep Warm’‘Keep Warm’ Mantener Caliente Para programar ‘Keep Warm’Para cancelar el Modo Sabático Cierre Automático Modo SabáticoNotas Sobre el Modo Sabático Ajuste de la temperatura del horno Cambio de la temperatura de F/C‘Favorite’ Favorito Respiradero del Horno Ventilador del hornoParrillas del Horno Posiciones de la ParrillaDos parrillas Use la posición 3 y 6 o 2 y Media Parrilla Create-A-SpaceMRHorneado de Pasteles de Capas en Dos Parrillas Coloque los pasteles en las parrillas como se muestraPara diferir un ciclo de autolimpieza Para programar ‘Self-Clean’ AutolimpiezaAntes de la Autolimpieza Limpie el marco del horno, el marco deHumo y Olores Después del ciclo de autolimpiezaDurante el ciclo de autolimpieza SonidosProcedimientos de Limpieza Pieza Procedimiento DE LimpiezaCuidado y Limpieza Mantenimiento Para sacar Retiro de la Estufa a GasGaveta de Almacenamiento Para volver a colocarProblema Solución Localización y Solución de AveríasPáginas Códigos de ErroresEl horno no se autolimpia Verifique si la puerta está cerradaDE Maytag Corporation