Maytag MGS5875BDW Care & Cleaning, Cleaning Procedures, Part, display area, continued

Page 21
Care & Cleaning

Cleaning ProceduresCare & Cleaning

Cleaning Procedures

PART CAUTION

Be sure appliance is off and all parts are cool before handling or cleaning. This is to avoid damage and possible burns.

To prevent staining or discoloration, clean appliance after each use.

If a part is removed, be sure it is correctly replaced.

*Brand names are registered trademarks of the respective manufacturers.

**To order call 1-877-232-6771 USA or

1-800-688-8408 Canada.

PART

PROCEDURE

Burner Caps and

Removable Burner Caps

Sealed Gas

Allow burner to cool. Remove burner cap and wash in soapy water with a plastic scouring pad. For

Burners

 

stubborn soils, clean with a soap-filled, nonabrasive pad or Cooktop Cleaning Creme*

 

 

(Part #20000001)** and a sponge.

 

Do not clean in the dishwasher or self-cleaning oven.

 

Sealed Gas Burners

 

Clean frequently. Allow burner to cool. Clean with soap and plastic scouring pad. For stubborn soils,

 

 

clean with a soap-filled, nonabrasive pad. Do not enlarge or distort holes.

 

Be careful not to get water into burner ports.

 

Use care when cleaning the ignitor. If the ignitor is wet or damaged the surface burner will not light.

 

 

 

Burner Grates -

Wash with warm, soapy water and a nonabrasive, plastic, scrubbing pad. For stubborn soils,

Porcelain on

 

clean with a soap-filled, nonabrasive, plastic pad or Cooktop Cleaning Creme* (Part #20000001)**

Cast Iron

 

and a sponge. If soil remains, reapply Cooktop Cleaning Creme*, cover with a damp paper towel and

 

 

soak for 30 minutes. Scrub again, rinse and dry.

 

Do not clean in the dishwasher or self-cleaning oven.

 

 

 

Clock and

To activate control lock for cleaning, see “Locking the Controls” page 8.

Control Pad

Wipe with a damp cloth and dry. Do not use abrasive cleaning agents as they may scratch the finish.

Area

Glass cleaners may be used if sprayed on a cloth first. DO NOT spray directly on control pad and

 

 

display area.

 

 

 

Control Knobs

Remove knobs in the OFF position by pulling forward.

 

Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.

 

Turn on each burner to be sure the knobs have been correctly replaced.

 

 

Cooktop and

Porcelain enamel is glass fused on metal and may crack or chip with misuse. It is acid resistant, not acid proof.

Control Panel -

All spillovers, especially acidic or sugary spillovers, should be wiped up immediately with a dry cloth.

Porcelain Enamel

When cool, wash with soapy water, rinse and dry.

 

Never wipe off a warm or hot surface with a damp cloth. This may cause cracking or chipping.

 

Never use oven cleaners, abrasive or caustic cleaning agents on exterior finish of range.

 

 

 

Storage Drawer

When cool, wash with warm soapy water, rinse and dry. Never wipe a warm or hot surface with a damp

and Door

 

cloth as this may damage the surface and may cause a steam burn.

Handles -

For stubborn soil, use mildly abrasive cleaning agents such as baking soda paste or Bon Ami*. Do not use

Painted Enamel

 

abrasive cleaners such as steel wool pads or oven cleaners. These products will scratch or permanently

 

 

damage the surface.

 

Note: Use a dry towel or cloth to wipe up spills, especially acidic or sugary spills. Surface may

 

discolor or dull if soil is not immediately removed. This is especially important for white surfaces.

 

 

 

 

 

continued . . .

20

Image 21
Contents Table of Contents Use & Care GuideGas Slide-In Range Precision Touch Control Recognize Safety Symbols, Words, Labels Important SafetyInstructions General InstructionsChild Safety Important Safety InstructionsTo Prevent Fire or Smoke Damage In Case of FireUtensil Safety Cooking SafetySelf-Clean Oven Cleaning SafetyImportant Safety Notice and Warning Save These Instructions for Future ReferenceSetting the controls Operating Surface Burners During a Power FailureSurface Cooking Surface ControlsCooktop Power Boost High Performance BurnerSealed Burners Simmer BurnerOven Cooking Using the TouchpadsControl Panel ClockFault Codes TimerTo cancel the Clock display To restore the Clock displayBaking with Convection BakingBaking Notes Baking Differences Between Your Old and New OvenRoasting With Convection Roasting NotesTo set Convect Roast To cancel Cook & Hold at any time When the cooking time has elapsedCook & Hold Delay Cook & HoldBroiling Broiling ChartBroil Notes To set BroilKeep Warm To cancel Keep WarmKeep Warm Notes To set Keep WarmTo cancel the Sabbath Mode Automatic Shut-Off Sabbath ModeSabbath Mode Notes To adjust the oven temperature Adjusting the Oven TemperatureTo cancel a Favorite cycle in progress Changing Temp F/COven Vent Oven FansOven Light Oven BottomBaking Layer Cakes on Two Racks Create-A-SpaceTM Half RackBefore Self-Cleaning Care & CleaningTo set Self-Clean To Delay a Self-Clean CycleAfter Self-Cleaning During the Self-Clean CycleSmoke and Smells SoundsCleaning Procedures Care & CleaningPROCEDURE PARTDO NOT USE ANY CLEANING PRODUCT CONTAINING CHLORINE BLEACH DO NOT USE ABRASIVE OR ORANGE CLEANERSALWAYS WIPE WITH THE GRAIN WHEN CLEANING Oven Door MaintenanceOven Window Leveling LegsStorage Drawer Removal of Gas ApplianceElectrical Connection Always disconnect power to appliance before servicingTroubleshooting PROBLEMSOLUTION Oven did not clean properly Page LIMITED WARRANTY MAYTAG MAJOR APPLIANCE WARRANTYITEMS EXCLUDED FROM WARRANTY This limited warranty does not cover DISCLAIMER OF IMPLIED WARRANTIES LIMITATION OF REMEDIESCuisinière à gaz encastrable à touches de précision Guide d’utilisation et d’entretienTable des matières Instructions de sécuritéAVERTISSEMENT Reconnaître les étiquettes, paragraphes et symboles sur la sécuritéInstructions de sécurité importantes Instructions générales Instructions de sécurité importantesPour éviter un incendie ou des dommages par la fumée En cas d’incendieCuisson et sécurité Familiarisation avec l’appareilNettoyage et sécurité Ustensiles et sécuritéFour autonettoyant Avertissement et avis important pour la sécuritéConserver ces instructions pour consultation ultérieure Boutons de commande de la surface de cuisson Commandes de la surface de cuissonRéglage des commandes Cuisson sur la surfaceSurface de cuisson Brûleur de haute performance Power BoostBrûleurs scellés Brûleur de mijotageCuisson dans le four Tableau de commandeUtilisation des touches HorlogeCuisson dans le four Verrouillage des commandes et de la porte du fourMinuterie Réglage de l’horlogeCuisson courante Codes d’anomalieCuisson avec convection Remarques sur la cuisson courante au fourRôtissage avec convection Cuisson dans le fourRemarques sur le rôtissage Programmation du rôtissage avec convectionCuisson et maintien différés Cuisson et maintienLorsque la durée de cuisson s’est écoulée Programmation de Cuisson et maintienRemarques sur la fonction de maintien au chaud Maintien au chaudProgrammation du Maintien au chaud Annulation du maintien au chaudRemarques sur la cuisson au gril Cuisson au grilTableau de cuisson au gril Programmation de la cuisson au grilArrêt automatique Mode sabbat Remarques sur le mode sabbatAnnulation du mode sabbat Changement de la température F/C Ajustement de la température du fourFavori Ajustement de la température du fourAllumage sans flamme de veille RéinstallationVentilateur du four Évent du fourPositions des grilles Demi-grille Create-A-SpaceTMCuisson de gâteaux à étages sur deux grilles Avant l’autonettoyage NettoyageProgrammation de l’autonettoyage Démarrage différé d’un cycle d’autonettoyagePendant le cycle d’autonettoyage Après le cycle d’autonettoyageFumée et odeurs BruitsPIÈCE Méthodes de nettoyageNETTOYAGE directement sur les touches de commande ou sur l’afficheurest particulièrement important dans le cas de surfaces blanches NE PAS UTILISER DE PRODUITS DE NETTOYAGE CONTENANT DU JAVELLISANTNE PAS UTILISER DE NETTOYANTS « ORANGE » OU ABRASIFS Porte du four EntretienPieds de réglage de l’aplomb Lampe du fourTiroir de remisage Déplacement d’un appareil à gazRaccordement électrique DéposeRecherche des pannes PROBLÈMESOLUTIONDéterminer que l’appareil n’a pas été programmé pour un autonettoyage différé. Voir PROBLÈMEGARANTIE LIMITÉE GARANTIE DES GROS APPAREILS MÉNAGERS MAYTAG CORPORATIONARTICLES EXCLUS DE LA GARANTIE La présente garantie limitée ne couvre pasEstufa a Gas Deslizante con Control a Precisión Sensible al Tacto Guía de Uso y CuidadoTabla de Materias Instrucciones ImportantesSeguridad InstruccionesReconozca los símbolos, advertencias, etiquetas de seguridad ADVERTENCIAInstrucciones Generales Instrucciones Importantes sobre SeguridadPara Evitar un Incendio o Daño Causado por el Humo En Caso de IncendioSeguridad Para Cocinar GeneralidadesUtensilios Apropiados Seguridad de la LimpiezaHorno Autolimpiante Aviso y Advertencia Importante Sobre Seguridad Conserve estas Instrucciones para Referencia FuturaAVISO IMPORTANTE RESPECTO A LOS PAJAROS DOMESTICOS Controles Superiores Cocinando en la EstufaEncendido Sin Piloto Funcionamiento durante una Interrupción de la Energía EléctricaCubierta Quemador de Alto Rendimiento Power BoostQuemadores Sellados Rejillas de los QuemadoresPanel de Control Cocinando en el HornoUso de las Teclas ‘Clock’ Reloj‘Timer’ Temporizador Códigos de ErroresPara cancelar el despliegue del reloj Para cancelar el temporizadorHorneado por Convección HorneadoDiferencias del horneado entre su horno antiguo y su horno nuevo modelos selectos‘Cook & Hold’ Cocción y Asado por ConvecciónNotas sobre Asado Mantener Caliente‘Delay Cook & Hold’ Para cancelar ‘Cook & Hold’ en cualquier momento‘Cook & Hold’ Diferido Cuando haya expirado el tiempo de cocciónNotas Sobre Asado a la Parrilla ‘Broiling’ Asar a la ParrillaTabla de Asar a la Parrilla Para programar ‘Broil’‘Keep Warm’ Mantener Caliente Para cancelar ‘Keep Warm’Notas sobre ‘Keep Warm’ Para programar ‘Keep Warm’Cierre Automático Modo Sabático Para cancelar el Modo SabáticoNotas Sobre el Modo Sabático 72 horasAjuste de la temperatura del horno Para cancelar un ciclo favorito en progresoCambio de la temperatura de F/C ‘Favorite’ FavoritoVentiladors del horno Encendido sin PilotoPanel Inferior del Horno Parrillas del HornoMedia Parrilla Create-A-SpaceMR Posiciones de la ParrillaHorneado de Pasteles de Capas en Dos Parrillas parrillasCuidado y Limpieza Para programar ‘Self-Clean’ AutolimpiezaAntes de la Autolimpieza Para diferir un ciclo de autolimpiezaDespués del ciclo de autolimpieza Durante el ciclo de autolimpiezaHumo y Olores SonidosProcedimientos de Limpieza Cuidado y LimpiezaPIEZA PROCEDIMIENTO DE LIMPIEZAEsto es especialmente importante en las superficies blancas Cuidado y LimpiezaNO USE LIMPIADORES “ORANGE” NI LIMPIADORES ABRASIVOS SIEMPRE LIMPIE LAS SUPERFICIES DE ACERO A FAVOR DEL GRANOPuerta del Horno MantenimientoTornillos Niveladores Luz del HornoGaveta de Almacenamiento Retiro de la Estufa a GasConexión Eléctrica Siempre desenchufe el electrodoméstico antes de efectuar reparacionesLocalización y Solución de Averías PROBLEMASOLUCIÓNSOLUCIÓN PROBLEMAGARANTÍA DE LOS ELECTRODOMÉSTICOS PRINCIPALES DE MAYTAG CORPORATIONGARANTÍA LIMITADA EXCLUSIONES DE LA GARANTÍA Esta garantía limitada no cubre