Omega Engineering 20 Information, Block s/nid, Unit s/n, S/w version, H/w version, Configuration

Page 29

Program Information

to select ]

Program Information

Pressing “Enter”

while a program is

running will give information about the current run including which program is actually running and the unit status e.g. holding or ramping.

An example is shown here.

7. Information

The Information field on the front screen contains all the unit-specific information such as serial number and software version.

Press “Enter” information.

to access the unit

Block Type:		2048x0.25ml
Block s/nid	123456789139160-2
Unit s/n	GP0000C3C123456-0
S/w version		146.z.zz
H/w version		2.ZZ01
Comms address		1
Unit cycles		624
Block cycles		69

8. Configuration

The complete list is displayed here.

Warning! The Configuration software should only be accessed by designated personnel, as some parameters can be changed or may be lost when using it.

MethodsPrograms Information

Configuration

[ ,

[0]	The Configuration field on the front screen
	allows a system administrator access to

set up all the default settings for the programs, time and date settings and to change and remove passwords.

29

Image 29

Contents Thermal Cyclers TCY 20, 25, 30User’sGuide Shop online atInternet e-mail info@omega.com OMEGAnet Online Service omega.comServicing North America For immediate technical or application assistanceContents Operator Safety 2. Safety and installation1. Introduction Replacement cable InstallationUnpacking ELECTRICIANWorking Conditions Temperature 3. Cycler TCY SpecificationHeating/Cooling Rate Heated LidDimensions 4. User operation and consumablesPower Heated lid0.5ml Tubes ProgramsMethods00 TCYTCto select Information Configuration5. Front panel controls ConfigurationPrograms MethodsThe End, Finish or Exit key The keysThe Up arrow key The Down arrow keyThe Alpha/Numeric keys 6. Programming the CYCLERStage MethodsPrograms00 Information ConfigurationCycle StepSTEP 2 STEP TEMPLATERun ProgramMethod Option 1 Creating programs using templatesTo save the program To give a program a nameSet password to select ProgramsMethods00 Information Configurationto select DONNA 7 Run programmethod To edit a field or step in an existing program10.0 Post hold72.0ºC 5m0010.0ºCºC UNNAMED #To set a password for a selected program 105ºCProgramming Example programsNew*New- program ** 2 STEP TEMPLATE 5012 3 STEP TEMPLATE Typical 3-Step PCRTo delete a step To insert additional stepsto edit the step as described abovestage to insertTo add a new stage before an existing one To add a new stage at the endThe prompt line will flash between ‘CHANGE TO PAUSE?’ and ‘YES or NO’ To insert a ‘pause’ into a programTemperature profile of incremented Hold Time at step 3 of each cycle To program increment or decrement temperature or timePress “Enter” Press “Pause” to go into edit modetwice to go into edit GEORGE Run ProgrammethodView methodProgram Stopping what you are doingNewprogramMethods Run methodProgramto select To run a program58.0ºC SampleHold @ 72.0ºC7. Information 8. ConfigurationBlock s/nid Unit s/nxxxx ProgramSettingsdefaultsPasswordsFormat memory Settingswill delete ThisSURE ? Passwords9. Notes on transferring protocols from other thermal cyclers Cleaning your CYCLER 10. User maintenanceHeater Block removal Underside of the CYCLER TCY11. Some frequently asked questions Fault Finding 12. Additional informationInsulation testing FusesRETURN REQUESTS/INQUIRIES WARRANTY/DISCLAIMERPRESSURE, STRAIN AND FORCE TEMPERATUREFLOW/LEVEL pH/CONDUCTIVITY