Omega Engineering 20, 48, 30, 25 manual twice to go into edit

The prompt line will change to flash between ‘CHANGE STEP?’ and ‘YES’ or ‘NO’.

Press “Enter”

The cursor will again move into the edit mode.

Now press the “Up Arrow” key

The step will change to ‘fst’, meaning “first”, and the software will insert another line after it entitled ‘lst’, meaning “last”.

Press “Enter”	twice to go into edit
mode.

Use the “Alpha/numeric” keys to change the values of the ‘fst’ line to the first temperatures and/or times you require.

Press “Enter” change.

after each field you

You will exit ‘Edit Mode’ when you reach the end of the line.

Use the “Down Arrow” key to move onto the ‘lst’ line.

Press “Enter” to edit the step.

Use the “Alpha/numeric” keys to change the values of the ‘1st’ line to the final temperatures and/or times you require.

Press “Enter” change.

for each field you

You will exit ‘Edit Mode’ when you reach the end of the line.

When you run the program it will automatically increment or decrement in equal steps from the first time and/or temperature to the last over the number of cycles in the stage. For example: if the

25