Omega Engineering 30, 48, 20, 25 ProgramSettingsdefaults, xxxx, to select, PasswordsFormat memory

1234

SettingsProgram defaults PasswordsSettings FormatPasswordsmemory SelfControl-calibrateerreset

Access to the ‘Configuration’ set up is password protected.

Default admin passwords is 1234

To enter configuration, use the alpha keys to type in ‘1234’

Press “Enter”

There are a number of options which can be changed; these are listed here.

Use the “Up Arrow” and “Down Arrow” keys to select then press “Enter” to access any of the options. Each option is discussed in detail below.

Settings

ProgramSettingsdefaults Highlight ‘Settings’ then press “Enter”

SettingsPasswords

PasswordsFormat memory

SelfControl-calibrateerreset

SettingsProgram defaults Passwords FormatPasswordsmemory Controller reset Self-Calibrate

Highlight ‘Settings’ then press “Enter”

Set		xx/xx/xx
Set date
Set time		xx:xx
AutoDate restartformat		donmy
BeeperAuto restart		on
Beeper		on
Coms address		1
Coms	address	1
Coms speed		19200
Coms	speed	4800
[	, to select ]

The complete list of settings is given here.

Auto restart “on” will allow the unit to restart from where it left off should there be a power failure and the power returns.

The “Comms address” refers to the location of a unit in a daisy chain and must be unique if there are several units linked to each other.

The optimum “Coms speed” is set at 19200. When using a control software, ensure all cyclers are set to the same value.

Edit any line as described for ‘Program

defaults’ above. Press “Enter”	to
accept the new value.

30