Kenmore 596.6523*403 manual Connect to Refrigerator, Complete the Installation

Page 6

5.Usingacordlessdrill,drilla%"holeinthecoldwaterpipe

youhaveselected.

A

%

A.

Cold

water pipe

E. Compression sleeve

B.

Pipe

clamp

F. Shutoff

valve

C.

Copper tubing

G. Packing

nut

D.

Compression nut

 

 

6.Fasten the shutoff valve to the cold water pipe with the pipe clamp. Be sure the outlet end is solidly in the 1/4"drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws slowly and evenly so the washer makes a watertight seal. Do not overtighten or you may crush the copper tubing.

7.Slip the compression sleeve and compression nut on the copper tubing as shown. Insert the end of the tubing into the outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing in a container or sink, and turn ON the main water supply. Flush the tubing until water is clear. Turn OFF the shutoff valve on the water pipe.

Connect to Refrigerator

1.Remove plastic cap from water valve inlet port. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on copper tubing.

2.Create a service loop with the copper tubing. Avoid kinks when coiling the copper tubing. Secure copper tubing to refrigerator cabinet with a "P" clamp.

B_@

@

C

Di

Ei

A.

Copper tubing

D. Compression sleeve

B.

"P" clamp

E. Water valve inlet port

3.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

Complete the Installation

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Plug into a grounded 3 prong outlet.

NOTE: Allow 24 hours to produce the first batch of ice. Discard

the first three batches of ice produced. Allow 3 days to completely fill the ice container.

TOOLS NEEDED: 5_611, 3/811, 1/4"hex-head socket wrench, a #2 Phillips screwdriver, and a flat-blade screwdriver.

IMPORTANT:

•All graphics referenced in the following instructions are included later in this section after "Final Steps." The graphics shown are for a right-hand swing refrigerator (hinges factory installed on the right).

If you only want to remove and replace the doors see "Remove Doors and Hinges" and "Replace Doors and Hinges."

Before you begin, turn the refrigerator control OFF, and remove food and adjustable door or utility bins from the doors.

Remove and Replace Refrigerator Door Handles

To remove the handle, remove the screw attaching the trim to the upper end of the handle. Using a flat-blade screw driver wrapped in masking tape, pry the trim piece from the lower end of the handle. Then, remove the screws attaching the handle to the door. See Front Mount graphic 2.

•TOreplace handle, reverse directions.

C. Compression nut

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Models/Modelos/Modles Table of Contents Kenmore Appliance WarrantyRefrigerator Safety Before You Throw Away Your Old Refrigerator or FreezerRemove the Packaging Clean Before UsingWhen Moving Your Refrigerator Explosion HazardRecommended Grounding Method Water PreseureConnect to Water Line Tools NeededComplete the Installation Connect to RefrigeratorRemove and Replace Refrigerator Door Handles Remove Door and Hinges Replace Door and HingesBottom Hinge Top HingeCenter Hinge Front MountCONDITION/REASON Adjustment Temperature ControlsAdjusting Controls Refrigerator USERefrigerator Features Ice Production RateRemember To replace crispers cover Freezer FeaturesTo remove the crispers cover Meat Storage GuideTo remove and replace the bins Door FeaturesTo remove wire basket To remove and replace the shelfChanging the Refrigerator Light Bulb To Clean Your RefrigeratorRefrigerator Care Changing the Freezer Light BulbTroubleshooting MovingRefrigerator will not operate Door is difficult to open Temperature is too warmRefrigerator seems noisy There is interior moisture buildupProtection Agreements Stainless Steel Cleaner & PolishReplacement Parts Master Protection AgreementsCaracterjsticas DEL Congelador Garantia SeguridadCaracterjsticas CuidadoGARANTiA Limitada DE UN Aiio Exclusion DE Garantas Implicitas Limitacion DE RecursosRegistro DEL Producto Seguridad DEL Refrigerador Peligro de Asfi×iaAntes de tirar su viejo refrigerador o congelador Instrucciones DE Instalacion C6mo mover su refrigeradorPresibn del agua ImportanteHerramientas Necesarias Conexibn al refrigerador Cambio del sentido de apertura de las puertas opcional Cbmo quitar la puerta y las bisagrasPasos finales Bisagra superior Bisagra centralBisagra inferior Controles de temperatura USO DE SU RefrigeradorCbmo ajustar los controles Ajuste recomendadoPara encender y apagar la fbrica de hielo Ritmo de produccibn de hieloAjuste RecuerdePara quitar y volver a colocar el caj6n para bocadillos Guia para la conservacibn de carnesPara quitar la tapa delde los cajbncajones para verduras Para instalar y quitar el estante para hieloLA Puerta Cuidado DE SU Refrigerador Para limpiar su refrigeradorCbmo cambiar el foco del refrigerador Si Ud. decide apagar el refrigerador antes de irse MudanzaLa puerta no cierra completamente Solucion DE ProblemasParece que el refrigerador es ruidoso Hay un fusible de la casa fundido o se disparb elEs dificil abrir la puerta Hay acumulacibn de humedad en el interiorLos cubes de hielo son huecos o pequefios Contratos maestros de proteccibn RefaccionesLimpiador de acero inoxidable Table DES Matii RES Garantie DES Appareils MI Nagers KenmoreAvant de jeter votre vieux rfrigrateur ou conglateur SI Curiti DU RI Frigi RateurLlVlPORTANTES INSTRUCTiONS Enlever les portes de votre vieux refrigrateurNettoyage avant rutilisation Instructions DinstallationEnlvement des matriaux demballage Risque du poids excessifOutillage Requis Mthode recommande de raise la terrePression de Ieau Alimentation en eau par osmose inverseRaccordement au rfrigrateur Dpose et rinstallation des poignes de porte du rfrigrateur Dpose des portes et des charnieresInversion du sens douverturede la porte facultatif Rinstallation Porte et charnires Etapes finalesCharnibre supdrieure Charnibre centrale Montage frontalRglages des commandes Commandes de temperatureRglage recommande Utilisation DU RI Frigi RateurAjustement RefrigerateurTaux de production des glagons Mise en marche/arrt de la machine & glaonsGuide dentreposage des viandes Pour rinstaller le couvercle du ou des bacsPour retirer et rinstaller le tiroir a collations Pour retirer le couvercle du ou des bacsPour enlever et rinstaller la tablette Pour enlever et reinstaller la tablette du conglateurDpose du panier mtallique Entretien DU RI Frigi Rateur Dplacement du cadre du seau de porteRemplacement de Iampoule du compartiment de rfrigration Nettoyage de votre rfrigrateurRemplacement de Iampoule du compartiment de conglation DmnagementLa porte ne se ferme pas compltement DepannageLe rfrig6rateur semble bruyant Un fusible est-il grill ou un disjoncteur sest-il ouvert?GoOt, odeur ou couleur grise des glagons La porte est difficile & ouvrirLes glagons sont creux ou petits T-il un transfert dodeurs de nourriture? Utiliser desContrats principaux de protection Contrats DE ProtectionNettoyant et poll pour acier inoxydable Vrification annuelle dentretien prventif sur demandeYour Home W10137664A
Top Page Image Contents