McCulloch ZM3016 BF manual Blade Control Lever, Manual Transport, Seat Adjustment Lever, Controls

Page 22

Blade Control Lever

CONTROLS

Blade Control Lever

To engage the mower blades, slowly lift the lever up and into the the lock notch.

WARNING!

No adjustments or maintenance to be carried out unless:

•the engine stopped

•the ignition key removed

•the parking brake activated

Manual Transport

When pushing or pulling the mower, be sure to engage the EZT Hydrogear bypass linkages. The EZT bypass linkages are located on the rear of the frame, below the rear engine guard.

•Raise the deck into the highest cutting position.

•Pull the EZT bypass linkages out and into the slots. Release linkages to hold in the bypass position.

•Release park brake.

•To reengage the EZT’s to drive, reverse the above procedure.

Seat Adjustment Lever

The seat can be adjusted lengthways. The lever is located at the right side of the seat (as seen by the driver in the seat). When making adjustments the lever is moved upward.

8058-074

Mower deck blade control lever in the disengaged position

8050-018

Set bypass linkages into slots on both sides

8058-124

Seat adjustment

22

Image 22

Contents Operator Manual ZM3016 BFIn order to implement improvements, specifications and designs can be altered without prior notification Contents Page General INTRODUCTIONCongratulations Driving and Transport on Public RoadsGood Service Manufacturing Numberxxxxxxxxxxxxxxx symbols and decalsXxxx xxxxxx IMPORTANT INFORMATIONperforming any remove safetyremove key before Whole bodySAFETY INSTRUCTIONS COULD SAFETYSafety Instructions THIS CUTTING MACHINE IS CAPABLEAlways wear eye protection when operating machine Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline There is risk for burns if touchedGeneral Maintenance Use protective glasses for maintenance workUse protective goggles Transport Spark ArrestorCONTROLS Control Locations1.Forward 2.Neutral 3.Neutral slot, Neutral lock Steering Control Levers4.Reverse Parking Brake Ignition SwitchThrottle Control Refueling Choke ControlRisk for burns if touched Tracking Fuel Shut Off ValveMower Deck Lifting Lever Always use the high position F to transportManual Transport Seat Adjustment LeverBlade Control Lever the engine stopped the ignition key removedSteering operationTraining To move forward and backwardBefore Starting Starting the EngineMove the throttle to the middle position operation Jumper cables To remove cables, reverse orderRunning Operating on Hills Mowing Tips Stopping the Engine operation MAINTENANCE Maintenance ScheduleCheck/adjust the mower deck Check/adjust throttle cableClean/replace the spark plugs Perform the 300-hourserviceReplacing battery BatteryTo clean battery and terminals Always use two wrenches for the terminal screwsSafety System Tire PressuresDeck Belt V-beltsTo replace deck belt EZT Belt Belt installationBlade replacement Cutting Blades1.Engage the parking brake Adjusting the Mower DeckLeveling Deck Use protective glasses when cleaning and washing CleaningRemoval and installation of caster wheel Caster WheelsLUBRICATION GeneralEngine Lubrication Front Wheel MountFront Wheel Bearings Steering Control ShaftsProblem TROUBLESHOOTINGCause The engine seems weak storage ServiceWinter Storage SCHEMATIC HEX HEAD CAP SCREWS TECHNICAL DATATorque Specifications U.S. Standard HardwareEngine ZM3016 BFTransmission Equipment Overall dimensionsRZ3019 BF ProductivityUSA Requirements CONForMITY CERTIFICATESCE Requirements SERVICE JOURNAL 25-HourService 50-HourService 100-HourService300-HourService At Least Once Each YearPage P/N 115 349327R1 03/19/10