McCulloch ZM3016 BF, 966564001 Safety System, Tire Pressures, Maintenance, Important Information

Page 36

Safety System

MAINTENANCE

Safety System

The machine is equipped with a safety system that prevents starting or driving under the following conditions.

The engine can only be started when:

1.The mower deck is disengaged.

2.The steering controls are in the outer, locked neutral position.

3.The driver is sitting in the driver’s seat.

4.The parking brake is on.

Make daily inspections to ensure that the safety system works by attempting to start the engine when one of the conditions is not met. Change the conditions and try again.

If the machine starts when one of these conditions is not met, turn the machine off and repair the safety system before using the machine again.

Make sure the engine stops when the park brake is not engaged and the operator leaves the seated position.

Check that the engine stops if the mower blades are engaged and the driver temporarily moves off the drivers seat.

8050-020

Start conditions

IMPORTANT INFORMATION

In order to be able to drive, the driver must sit in the seat and release the parking brake before the steering controls can be moved into the neutral position, otherwise the engine will stop.

Tire Pressures

All tires should be at 15 psi / 103 kPa / 1 bar.

8011-564

Tire pressures

36

Image 36

Contents Operator Manual ZM3016 BFIn order to implement improvements, specifications and designs can be altered without prior notification Contents Page INTRODUCTION CongratulationsGeneral Driving and Transport on Public RoadsGood Service Manufacturing Numbersymbols and decals Xxxx xxxxxxxxxxxxxxxxxxxxx IMPORTANT INFORMATIONremove safety remove key beforeperforming any Whole bodySAFETY Safety InstructionsSAFETY INSTRUCTIONS COULD THIS CUTTING MACHINE IS CAPABLEAlways wear eye protection when operating machine Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline There is risk for burns if touchedGeneral Maintenance Use protective glasses for maintenance workUse protective goggles Transport Spark ArrestorCONTROLS Control LocationsSteering Control Levers 1.Forward 2.Neutral 3.Neutral slot, Neutral lock4.Reverse Ignition Switch Parking BrakeThrottle Control Choke Control RefuelingRisk for burns if touched Fuel Shut Off Valve Mower Deck Lifting LeverTracking Always use the high position F to transportSeat Adjustment Lever Blade Control LeverManual Transport the engine stopped the ignition key removedoperation TrainingSteering To move forward and backwardBefore Starting Starting the EngineMove the throttle to the middle position operation Jumper cables To remove cables, reverse orderRunning Operating on Hills Mowing Tips Stopping the Engine operation MAINTENANCE Maintenance ScheduleCheck/adjust throttle cable Clean/replace the spark plugsCheck/adjust the mower deck Perform the 300-hourserviceBattery To clean battery and terminalsReplacing battery Always use two wrenches for the terminal screwsSafety System Tire PressuresV-belts Deck BeltTo replace deck belt Belt installation Blade replacementEZT Belt Cutting BladesAdjusting the Mower Deck 1.Engage the parking brakeLeveling Deck Cleaning Removal and installation of caster wheelUse protective glasses when cleaning and washing Caster WheelsLUBRICATION GeneralFront Wheel Mount Front Wheel BearingsEngine Lubrication Steering Control ShaftsTROUBLESHOOTING ProblemCause The engine seems weak Service storageWinter Storage SCHEMATIC TECHNICAL DATA Torque SpecificationsHEX HEAD CAP SCREWS U.S. Standard HardwareZM3016 BF EngineTransmission Overall dimensions RZ3019 BFEquipment ProductivityCONForMITY CERTIFICATES USA RequirementsCE Requirements SERVICE JOURNAL 25-HourService 50-HourService 100-HourService300-HourService At Least Once Each YearPage P/N 115 349327R1 03/19/10