McCulloch ZM3016 BF, 966564001 manual Good Service, Manufacturing Number, Introduction

Page 6
Good Service

INTRODUCTION

Good Service

McCulloch’s products are sold only in specialized retail stores with complete service. This ensures that you as a customer receive only the best support and service. Before the product is delivered, the machine has, for example, been inspected and adjusted by

your retailer. See the certificate in the Service Journal in this operator’s manual.

When you need spare parts or support in service questions, warranty issues, etc., please consult the following professional:

This Operator’s Manual belongs to the machine with the manufacturing number:

Engine

Transmission

Manufacturing Number

The machine’s manufacturing number can be found on the printed plate affixed to the left in the engine compartment. Stated on the plate, from the top are:

The machine’s type designation (I.D.).

The manufacturer’s type number (Model).

The machine’s serial number (Serial no.)

Please have the type designation and serial number available when ordering spare parts.

The engine’s manufacturing number is stamped on one of the valve covers.

The plate states:

The engine’s model.

The engine’s type.

Code

Please have these available when ordering spare parts.

The wheel motors and hydrostatic pumps have a barcode decal affixed at the rear.

6

Image 6
Contents Operator Manual ZM3016 BFIn order to implement improvements, specifications and designs can be altered without prior notification Contents Page General INTRODUCTIONCongratulations Driving and Transport on Public RoadsGood Service Manufacturing Numberxxxxxxxxxxxxxxx symbols and decalsXxxx xxxxxx IMPORTANT INFORMATIONperforming any remove safetyremove key before Whole bodySAFETY INSTRUCTIONS COULD SAFETYSafety Instructions THIS CUTTING MACHINE IS CAPABLEAlways wear eye protection when operating machine Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline There is risk for burns if touchedGeneral Maintenance Use protective glasses for maintenance workUse protective goggles Transport Spark ArrestorCONTROLS Control LocationsSteering Control Levers 1.Forward 2.Neutral 3.Neutral slot, Neutral lock4.Reverse Ignition Switch Parking BrakeThrottle Control Choke Control RefuelingRisk for burns if touched Tracking Fuel Shut Off ValveMower Deck Lifting Lever Always use the high position F to transportManual Transport Seat Adjustment LeverBlade Control Lever the engine stopped the ignition key removedSteering operationTraining To move forward and backwardBefore Starting Starting the EngineMove the throttle to the middle position operation Jumper cables To remove cables, reverse orderRunning Operating on Hills Mowing Tips Stopping the Engine operation MAINTENANCE Maintenance ScheduleCheck/adjust the mower deck Check/adjust throttle cableClean/replace the spark plugs Perform the 300-hourserviceReplacing battery BatteryTo clean battery and terminals Always use two wrenches for the terminal screwsSafety System Tire PressuresV-belts Deck BeltTo replace deck belt EZT Belt Belt installationBlade replacement Cutting BladesAdjusting the Mower Deck 1.Engage the parking brakeLeveling Deck Use protective glasses when cleaning and washing CleaningRemoval and installation of caster wheel Caster WheelsLUBRICATION GeneralEngine Lubrication Front Wheel MountFront Wheel Bearings Steering Control ShaftsTROUBLESHOOTING ProblemCause The engine seems weak Service storageWinter Storage SCHEMATIC HEX HEAD CAP SCREWS TECHNICAL DATATorque Specifications U.S. Standard HardwareZM3016 BF EngineTransmission Equipment Overall dimensionsRZ3019 BF ProductivityCONForMITY CERTIFICATES USA RequirementsCE Requirements SERVICE JOURNAL 25-HourService 50-HourService 100-HourService300-HourService At Least Once Each YearPage P/N 115 349327R1 03/19/10