McCulloch 966564001, ZM3016 BF manual Lubrication, General

Page 41

LUBRICATION

LUBRICATION

8058-072

12/12 Every year 1/52 Every Week 1/365 Every day

Lubricate with grease gun Oil change Filter change

Lubricate with oil can Level check

General

Remove the ignition key to prevent unintentional movements during lubrication.

When lubricating with an oil can, it must be filled with engine oil.

When lubricating with grease, unless otherwise stated, use a high grade molybdenum disulphide grease.

For daily use, the machine should be lubricated twice weekly.

Wipe away excess grease after lubrication.

It is important to avoid getting lubricant on the belts or the drive surfaces on the belt pulleys. Should this happen, attempt to clean them with spirits. If the belt continues to slip after cleaning, it must be replaced. Gasoline or other petroleum products must not be used to clean belts.

41

Image 41

Contents ZM3016 BF Operator ManualIn order to implement improvements, specifications and designs can be altered without prior notification Contents Page Congratulations INTRODUCTIONGeneral Driving and Transport on Public RoadsManufacturing Number Good ServiceXxxx xxxxxx symbols and decalsxxxxxxxxxxxxxxx IMPORTANT INFORMATIONremove key before remove safetyperforming any Whole bodySafety Instructions SAFETYSAFETY INSTRUCTIONS COULD THIS CUTTING MACHINE IS CAPABLEAlways wear eye protection when operating machine Slope Operation Personal Safety EquipmentChildren There is risk for burns if touched Safe Handling of GasolineUse protective glasses for maintenance work General MaintenanceUse protective goggles Spark Arrestor TransportControl Locations CONTROLS4.Reverse Steering Control Levers1.Forward 2.Neutral 3.Neutral slot, Neutral lock Throttle Control Ignition SwitchParking Brake Risk for burns if touched Choke ControlRefueling Mower Deck Lifting Lever Fuel Shut Off ValveTracking Always use the high position F to transportBlade Control Lever Seat Adjustment LeverManual Transport the engine stopped the ignition key removedTraining operationSteering To move forward and backwardStarting the Engine Before StartingMove the throttle to the middle position IMPORTANT INFORMATION To remove cables, reverse order Jumper cablesRunning Operating on Hills Mowing Tips Stopping the Engine Manual Transport Maintenance Schedule MAINTENANCEClean/replace the spark plugs Check/adjust throttle cableCheck/adjust the mower deck Perform the 300-hourserviceTo clean battery and terminals BatteryReplacing battery Always use two wrenches for the terminal screwsTire Pressures Safety SystemTo replace deck belt V-beltsDeck Belt Blade replacement Belt installationEZT Belt Cutting BladesLeveling Deck Adjusting the Mower Deck1.Engage the parking brake Removal and installation of caster wheel CleaningUse protective glasses when cleaning and washing Caster WheelsGeneral LUBRICATIONFront Wheel Bearings Front Wheel MountEngine Lubrication Steering Control ShaftsCause TROUBLESHOOTINGProblem The engine seems weak Winter Storage Servicestorage SCHEMATIC Torque Specifications TECHNICAL DATAHEX HEAD CAP SCREWS U.S. Standard HardwareTransmission ZM3016 BFEngine RZ3019 BF Overall dimensionsEquipment ProductivityCE Requirements CONForMITY CERTIFICATESUSA Requirements SERVICE JOURNAL 25-HourService 100-HourService 50-HourServiceAt Least Once Each Year 300-HourServicePage 03/19/10 P/N 115 349327R1