McCulloch ZM3016 BF, 966564001 manual operation, Important Information

Page 26

operation

Open the fuel valve.

8050-010

Open the fuel valve

Press in and turn the ignition key to the start position

When the engine starts, immediately release the ignition key back to the run position.

IMPORTANT INFORMATION

Do not run the starter for more than 5 seconds each time. If the engine does not start, wait approximately 10 seconds before retrying.

8050-135

Turn to START position

8050-136

Release ignition to the RUN position

Image 26

Contents Operator Manual ZM3016 BFIn order to implement improvements, specifications and designs can be altered without prior notification Contents Page General INTRODUCTIONCongratulations Driving and Transport on Public RoadsGood Service Manufacturing Numberxxxxxxxxxxxxxxx symbols and decalsXxxx xxxxxx IMPORTANT INFORMATIONperforming any remove safetyremove key before Whole bodySAFETY INSTRUCTIONS COULD SAFETYSafety Instructions THIS CUTTING MACHINE IS CAPABLEAlways wear eye protection when operating machine Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline There is risk for burns if touchedGeneral Maintenance Use protective glasses for maintenance workUse protective goggles Transport Spark ArrestorCONTROLS Control Locations4.Reverse Steering Control Levers1.Forward 2.Neutral 3.Neutral slot, Neutral lock Throttle Control Ignition SwitchParking Brake Risk for burns if touched Choke ControlRefueling Tracking Fuel Shut Off ValveMower Deck Lifting Lever Always use the high position F to transportManual Transport Seat Adjustment LeverBlade Control Lever the engine stopped the ignition key removedSteering operationTraining To move forward and backwardBefore Starting Starting the EngineMove the throttle to the middle position operation Jumper cables To remove cables, reverse orderRunning Operating on Hills Mowing Tips Stopping the Engine operation MAINTENANCE Maintenance ScheduleCheck/adjust the mower deck Check/adjust throttle cableClean/replace the spark plugs Perform the 300-hourserviceReplacing battery BatteryTo clean battery and terminals Always use two wrenches for the terminal screwsSafety System Tire PressuresTo replace deck belt V-beltsDeck Belt EZT Belt Belt installationBlade replacement Cutting BladesLeveling Deck Adjusting the Mower Deck1.Engage the parking brake Use protective glasses when cleaning and washing CleaningRemoval and installation of caster wheel Caster WheelsLUBRICATION GeneralEngine Lubrication Front Wheel MountFront Wheel Bearings Steering Control ShaftsCause TROUBLESHOOTINGProblem The engine seems weak Winter Storage Servicestorage SCHEMATIC HEX HEAD CAP SCREWS TECHNICAL DATATorque Specifications U.S. Standard HardwareTransmission ZM3016 BFEngine Equipment Overall dimensionsRZ3019 BF ProductivityCE Requirements CONForMITY CERTIFICATESUSA Requirements SERVICE JOURNAL 25-HourService 50-HourService 100-HourService300-HourService At Least Once Each YearPage P/N 115 349327R1 03/19/10