STARTING/STOPPING INSTRUCTIONS
WARNING: Operate this unit only in a well- ventilated
outdoor area. Carbon monoxide exhaust fumes can be lethal in a confined area.
WARNING: Never operate the saw without the bar and
chain properly installed.
STARTING INSTRUCTIONS
1.Slide the STOP switch down (Fig. 2).
2.Rotate the choke lever up to the horizontal position (Fig. 3).
3.Pump primer bulb 10 times (Fig. 4).
4.Pull starter rope
5.If engine failed to start, rotate choke lever down to vertical position then repeat step 4 (Fig. 5).
6.When engine starts, warm up 10 sec.
Then depress safety/throttle trigger.The automatic choke will disengage when trigger is pulled (Fig.6).
7.Release throttle trigger for idle.
TO STOP: Slide stop switch up.
NOTE: This unit will not run with the choke lever in
horizontal Position 1.
NOTE: The unit uses Spring Assist Starting™, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope
C 
A
B
Fig. 1
D
Fig. 2
Horizontal position
Vertical position
Fig. 3
F
Fig. 4
Fig. 5
Automatic
A
B
Fig. 6
10