Starting the Engine
IMPORTANT!
Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and “O” for OFF or STOP.
WARNING!
Never start the engine from the operating position.
1.Slide the ignition switch to the “ON” position.
2.Set the throttle lever to the “fast idle”:
a.Squeeze the throttle lever toward the handgrip on the shaft tube.
b.Depress and hold the throttle lock button.
c.While depressing the throttle lock button, release the throttle lever.
3.Press the primer bulb until fuel can be seen flowing in the transparent return tube.
IMPORTANT!
The primer system only pushes fuel through the carburetor. Repeatedly press- ing the primer bulb will not flood the engine with fuel.
4.Set the choke lever to the CLOSED position if engine is cold.
5.While holding the outer tube firmly with left hand. Use your other hand to slowly pull the recoil starter handle until resistance is felt, then pull quickly to start the engine.
CAUTION!
Do not pull the recoil starter to the end of the rope travel. Pulling the recoil starter to the end of the rope travel can damage the starter.
WARNING!
The cutting attachment may move when the engine is started!
When the Engine Starts...
ON
Throttle Lock
Button
Slide ignition to ON
Close choke
Set the choke lever to the CLOSED position
6.When the engine starts, slowly move the choke lever to the “OPEN” posi- tion. (If the engine stops after the initial start, close the choke and restart.)
7.Operating the throttle will automatically disengage the fast idle setting.
IMPORTANT!
If the engine fails to start after several attempts with the choke in the closed position, the engine may be flooded with fuel. If flooding is suspected, refer to the ”Starting a Flooded Engine” section of this manual.
Primer Bulb | Return Tube |
Press primer
bulb...
Hold
the unit ¿UPO\
...and pull recoil | Make sure the | |
attachment is clear | ||
starter handle | ||
of obstructions! | ||
upward | ||
|
Open
After engine starts, move choke to OPEN position
ŶAfter the engine starts, allow the engine to warm up at idle 2 or 3 min- utes before operating the unit.
ŶAfter the engine is warm, pick up the unit and clip on the shoulder strap, if so equipped.
ŶAdvancing the throttle makes the cutting attachment move faster; releasing the throttle permits the attachment to stop moving. If the cutting attachment con-
tinues to move when the engine returns to idle, carburetor idle speed should be adjusted (see “Adjusting Engine Idle”.).
11