MTD YM75 manual OIL and Fuel Information, Oil and Fuel Mixing Instructions

Page 8

SECTION 4: OIL AND FUEL INFORMATION

Oil and Fuel Mixing Instructions

Old and/or improperly mixed fuel is the main reason for improper unit performance. Be sure to use fresh, clean unleaded fuel. Follow the instructions carefully for the proper fuel/oil mixture.

Definition of Blended Fuels

Today's fuels are often a blend of gasoline and oxygenates such as ethanol, methanol, or MTBE (ether). Alcohol-blended fuel absorbs water. As little as 1% water in the fuel can make fuel and oil separate. It forms acids when stored. When using alcohol-blended fuel, use fresh fuel (less than 60 days old).

Using Blended Fuels

If you choose to use a blended fuel, or its use is unavoidable, follow recommended precautions:

Always use fresh fuel mix per your operator's manual

Always agitate the fuel mix before fueling the unit

Drain the tank and run the engine dry before storing the unit

Using Fuel Additives

Thoroughly mix the proper ratio of 2-cycle engine oil with unleaded gasoline in a separate fuel can. Use a 40:1 fuel/oil ratio. Do not mix them directly in the engine fuel tank. See the table below for specific gas and oil mixing ratios.

NOTE: One gallon (3.8 liters) of unleaded gasoline mixed with one 3.2 oz. (95 ml.) bottle of 2-cycle oil makes a 40:1 fuel/oil ratio.

+

UNLEADED GAS

2-CYCLE OIL

1 US. GALLON + 3.2 FL. OZ.

(3.8 LITERS)

(95 ml)

1 LITER + 25 ml

MIXING RATIO - 40:1

The bottle of 2-cycle oil that came with your unit contains a fuel additive which will help inhibit corrosion and minimize the formation of gum deposits. It is recommended that you use only our 2-cycle oil with this unit.

If unavailable, use a good 2-cycle oil designed for air- cooled engines along with a fuel additive, such as STA-BIL®Gas Stabilizer or an equivalent. Add 0.8 oz.

(23 ml.) of fuel additive per gallon of fuel according to the instructions on the container. NEVER add fuel additives directly to the unit's fuel tank.

CAUTION: For proper engine operation and maximum reliability, pay strict attention to the oil and fuel mixing instructions on the

2-cycle oil container. Using improperly mixed fuel can severely damage the engine.

WARNING: Gasoline is extremely flammable. Ignited vapors may explode. Always stop the engine and allow it to cool before filling the fuel tank. Do not smoke while filling the tank. Keep sparks and open flames at a distance from the area.

WARNING: Remove fuel cap slowly to avoid injury from fuel spray. Never operate the unit without the fuel cap securely in place.

WARNING: Add fuel in a clean, well- ventilated outdoor area. Wipe up any spilled fuel immediately. Avoid creating a source of ignition for spilled fuel. Do not start the engine until fuel vapors dissipate.

NOTE: Dispose of the old fuel/oil mix in accordance to Federal, State and Local regulations.

8

Image 8
Contents Operator’s Manual Visit OUR WEB Site Important Safe Operation Practices Before OperatingWhile Operating Safety Warnings for Gas TrimmersOther Safety Warnings BSAFETY & International Symbols Know Your Unit ApplicationsInstalling and Adjusting the D-handle Assembly InstructionsOIL and Fuel Information Oil and Fuel Mixing InstructionsStopping Instructions STARTING/STOPPING InstructionsStarting Instructions Installing the Cutting Attachment or Add-On Operating InstructionsOperating the EZ-Link System Removing the Cutting Attachment or Add-OnsAdjusting Trimming Line Length Holding the TrimmerTips for Best Trimming Results Decorative TrimmingMaintenance and Repair Instructions Maintenance ScheduleLine Installation Winding the Inner Reel with New LineInstalling a Pre-wound Reel Releasing the Inner Reel Cleaning the SpeedSpoolSpeedSpool Replacement Parts Removing the Air Filter/Muffler Cover Air Filter MaintenanceCleaning the Air Filter Spark Arrestor Maintenance Reinstalling the Air Filter/Muffler CoverCarburetor Adjustment Clean Air FilterAdjust Idle Speed Check Fuel MixtureCleaning Accessories/Replacement PartsReplacing the Spark Plug Long Term StorageTroubleshooting Guide Trouble Possible Causes Corrective ActionDrive Shaft and Cutting Attachment SpecificationsEngine EPA Emission Control Warranty Statement MTD LLC Manuel de lutilisateur Table DES Matières Consignes DE Sécurité CaliforniePendant L’utilisation de L’appareil Symboles DE Sécurité ET Internationaux FAMILIARISEZ-VOUS Avec LA Désherbeuse ApplicationsInstallation ET Réglage DE LA Poignée EN D Instructions DE MontageFonctionnement DE LA Désherbeuse Mélange Dhuile ET DE CarburantInstructions Darrêt Instructions DE Démarrage ET ArrêtInstructions DE Démarrage Installation de laccessoire de coupe ou autre Mode D’EMPLORetrait de laccessoire de coupe ou autre Tenue DE LA Désherbeuse Réglage DE LA Longueur DU FILConseils Pour Bien Désherber Coupe DécorativeInstallation DU FIL Instructions D’ENTRETIEN ET RéparationsProgramme Dentretien Rembobiner le fil neuf sur le moulinet intérieurInstallation dun moulinet pré-enroulé Déroulement du moulinet intérieur Nettoyage du filtre à air Entretien DU Filtre À AIRRetrait du couvercle du filtre à air/silencieux Réinstallation du couvercle du filtre à air/silencieux Entretien DU PARE-ÉTINCELLESRéglage du ralenti Réglage DU CarburateurVérification du mélange de carburant Remplacement DE LA Bougie ACCESSOIRES/PIÈCES DE RechangeEntreposage Entreposage DE Longue DuréeProblème Causes possibles Solution Guide DE DépannageMoteur Arbre Dentrainement et Accessoire de CoupeCaracteristiques Garantie portant sur les normes antipollution de lEPA Garantie Limitée DU Fabricant Pour Manuel del Dueño/Operador Visite Nuestra Sito EN EL Internet Sección 1 Normas Para UNA Operacion Segura ParachispasAdvertencias de Seguridad Para Gasolina Sección 1b Símbolos DE Seguridad E Internacionales Sección 2 Conozca SU Recortador AplicacionesSección 3 Intrucciones DE Ensamble Instalación Y Ajuste DE LA Manija EN DSección 4 Informacion DEL Aceite Y DEL Combusible Instrucciones Para Mezclar EL Aceite Y EL CombustibleDefinición de los combustibles mezclados Uso de combustibles mezcladosInstrucciones DE Apagado Sección 5 Instrucciones DE Arranque Y ApagadoInstrucciones DE Arranque Sección 6 Instrucciones DE OPERACIóN Recorte Decorativo Como Sostener EL RecortadorConsejos Para Obtener Mejores Resultados AL Recortar Bobinado del carrete interior con línea nueva Programa DE MantenimientoInstalación DE LA Línea Instalación de un carrete interior prebobinado Limpieza DEL Speedspool Desconexión del carrete interiorMantenimiento DEL Filtro DE Aire Limpieza del Filtro de AireMantenimiento DEL Parachispas Ajuste DEL Carburador Verifique la mezcla del combustibleLimpie el filtro de aire Ajuste para marcha en vacíoCambio DE LA Bujia DE Encendido ACCESORIOS/PIEZAS DE RepuestoAlmacenamiento Almacenamiento ProlongadoProblema Causas posibles Medidas correctivas Sección 8 Guía Para Solución DE DesperfectosEje Impulsor y Accesorio de Corte Sección 9 EspecificacionesMotor Responsabilidades de Garantía de los Propietarios Notas E23 Parts List Engine Parts Model YM75 2-CYCLE GAS TrimmerBoom and Trimmer Parts Garantía Limitada DEL Fabricante Para