ASSEMBLY INSTRUCTIONS
NOTE: The only assembly required for your trimmer is to install the debris shield and the assist handle.
DEBRIS SHIELD INSTALLATION
1.Position the motor housing with string head carrier
facing up. (Fig. 1)
2.Slide debris shield over motor housing.
3.Fit the Edge guide (A) on the front part of the guard. Secure it at the rear with two screws (B). (Fig. 2)
A
B
Fig. 2
Fig. 1
ADJUSTMENT INSTRUCTIONS
ADJUST THE ASSIST HANDLE
1.Assemble the assist handle (A) to the unit, insert the bolt (B) to the handle adjustment knob (C) and tighten. (Fig. 3)
2.Loosen the adjustment knob (C) to adjust the assist handle to the most suitable position. (Fig. 4)
NOTE: The assist handle is ratcheted for variable operat- ing positions. Adjust to a comfortable position.
A
B C
Fig. 3
C
EDGING CONVERSION
1.Grip shaft firmly.
2.Push shaft locking button (A) forward, and rotate cut- ting assembly until an audible click is heard. (Fig. 5)
A
Fig. 5
BATTERY CHARGING
To charge the battery pack it must first be removed from the trimmer. To remove the battery pack. Put the trimmer horizontally on the ground at first. Then grasp both sides of the battery pack and depress the battery clip (A) as shown Fig 6. Now gently pull the battery pack from the housing.
Fig. 4
7