MTD 599 manual Operating Instructions, Trimmer Operation

Page 10

OPERATING INSTRUCTIONS

TRIMMER OPERATION

SWITCH

1.Push forward the lock-off switch (A) and depress the trigger switch (B) to start. (Fig. 10)

2.To stop the unit, simply release the trigger switch.

A

B

Fig. 10

3.TRIMMING / MOWING (Fig. 11). Swing trimmer with a sickle-like motion from side to side. Do not tilt the stringhead during the procedure. Test area to be trimmed for proper cutting height. Keep stringhead at same level for even depth of cut.

4.CLOSER TRIMMING (Fig. 12). Position trimmer straight ahead with a slight tilt so bottom of string- head is above ground level and string contact occurs at proper cutting point. Always cut away from opera- tor. Do not pull trimmer in toward operator.

5.FENCE/FOUNDATION TRIMMING. Approach trim- ming around chain link fences, picket fences, rock walls and foundations slowly to cut close without whipping string against the barrier. If the string comes in contact with rock, brick walls, or foundations, it will break or fray. If string snags fencing, it will snap off.

6.TRIMMING AROUND TREES. Trim around tree trunks with a slow approach so string does not con- tact bark. Walk around the tree trimming from left to right. Approach grass or weeds with the tip of the string and tilt stringhead slightly forward.

7.SCALPING (Fig. 12). Scalping refers to removal of all vegetation down to the ground. To do this, tilt the stringhead to about a 30 degree angle to the left. By adjusting the handle you will have better control dur- ing this operation. Always keep a distance of 50 feet (15 meters) from other people and animals when scalping. Do not attempt this procedure if there is any chance flying debris could injure operator, other peo- ple or cause damage to property.

8.OPERATING AS AN EDGER (Fig. 14). With the unit configured as an edger, hold it so the motor is to your left side so that debris is thrown to the rear. Always use eye protection.

Fig. 11

Fig. 12

Fig. 13

Fig. 14

9

Image 10
Contents Operator’s Manual Table of Contents Warranty StatementRules for Safe Operation Before OperatingImportant Safety Instructions for Charger Please Read Save These InstructionsBattery Pack Preparation for Recycling Safety Precautions When Using Charger and BatteryDisposal of the Exhausted Battery Warranty SymbolSafety and International Symbols Know Your Unit Assembly Instructions Adjustment InstructionsCharging Battery StartingOperating Instructions Trimmer OperationMaintenance Instructions Replace the Spool of Nylon LineMaintenance Instructions Maintenanace Specification Parts List Parts No DescriptionPage MTD LLC Manuel de Utilisation Table DES Matières Declaration DE GarantieSI Vous Avez DES QUESTIONS, Appelez LE Consignes DE SécuritéAvant Utilisation Avertissement Avertissement Dansle cas Instructions DE Securite Importante Pour LE ChargeurPour SE Defaire DES Batteries Usagees Preparation DE LA Batterie Amovible Pour SON RecyclageSymboles DE Sécurité ET Internationaux Symbole Signification Symbole Alerte DE SécuritéFAMILIARISEZ-VOUS Avec Votre Appareil Instructions DE Reglage Installation DU PARE-DÉBRISInstructions Pour Montage Instructions Pour AjusterCharge DE LA Batterie Charger LA BatterieInstructions D’UTILISATION Fonctionnement DU COUPE-HERBERemplacement DE LA Bobine DE FIL DE Nylon Instructions DE MantenimientoInstructions DE Mantenimiento Mantenimiento Caractéristiques Liste DES Pièces Référence DescriptionPage Garantie Limitée DU Fabricant Pour Manuel del Dueño/Operador Índice Declaración DE GarantíaReglas DE Funcionamiento Seguro SI Tiene PREGUNTAS, Llame ALAdvertencia Instrucciones DE Seguridad Importantes Para EL Cargador Precauciones DE Seguridad AL Usar EL Cargador Y LA BateriaAdvertencia sacarlas Explicacion DE NOTA, Advertencia Y Simbolo DE GarantiaAdvertencia Conozca SU Bordeadora DE Césped Instrucciones DE Ajuste Instrucciones DE EnsambleInstrucciones DE Ajuste Transformacion a DesorilladoraCarga DE Baterías Carga DE LA BateríaInstrucciones DE Operacion Operación DEL Cortador OrilladorInstrucciones DE Maintenimiento Sustitución DEL Carrete DEL Cable DE NylonInstrucciones DE Maintenimiento Precaucion practicar Especificaciones Lista DE Piezas Pieza No DescripciónNotas MTD LLC Stop