Magnavox MSW 990/17, MCS 990/17, MMX450/17 Tuner, Tuning to radio stations, Storing radio stations

Page 24

MFX450_eng 11/26/02 3:21 AM Page 23

TUNER

Tuning to radio stations

You can search for radio stations by scanning the frequency band. You can also key in the frequency of a known radio station. If an FM station is being broadcast and received in stereo, STEREO is shown.

Searching for radio stations

1Turn SOURCE SELECT to select the tuner. yTUNER is displayed.

2Select a waveband by pressing TUNER BAND repeatedly. yThe selected waveband is displayed.

3Keep 1 or 2 pressed for approximately 1 second.

ySEARCH is displayed and the tuner tunes to a station with sufficient strength.

4Repeat this procedure until you find the desired station.

•To fine tune to a weak transmitter, briefly press 1 or 2 as often as necessary for optimum reception.

Tuning to a radio station by frequency (with the remote control only)

1Press TUNER.

yTUNER is displayed.

2Press FR. D..

y_ is displayed.

3Use 1–0 to key in the frequency of a radio station.

Notes: Only valid numbers within the frequency range of the tuner can be keyed in.

Storing radio stations

You may store up to 30 radio stations in the memory. The receiver can select and program radio stations by itself or you can choose them yourself.

Automatic programming

1Choose * TUNER from the menu and press NEXT 2.

2Choose AUTO INSTALL and press NEXT 2.

yThe preset number where programming will start, the waveband and AUTO are displayed.

3Turn TUNER PRESET X to change the preset number where programming should start.

4Use TUNER BAND to switch to the desired waveband.

5Press ENTER / OK to start programming.

yAUTO INSTALL flashes and all available radio stations are programmed, this may take a few minutes. Programming is done when AUTO INSTALL stops flashing.

Manual programming

1Choose * TUNER from the menu and press NEXT 2.

2Choose MAN INSTALL and press NEXT 2.

yA preset number, the waveband and the frequency are displayed.

3Turn TUNER PRESET X to change to the preset number where the radio station should be stored.

4Tune to the desired radio station (see “Searching for radio stations”).

English

Switching FM sensitivity

You can switch the tuner to a lower search sensitivity, to search only for stations with a strong signal (FM only).

1Turn SOURCE SELECT to select the tuner. yTUNER is displayed.

2Press SENS. on the receiver.

yEither SENS HI or SENS LO is displayed for 5 seconds.

Note: While searching for radio stations, the actual sensitivity is displayed. In this case, SENS LO means the tuner is looking only for radio stations with a strong signal.

5Press ENTER / OK to confirm your selection.

ySTORED is displayed briefly. The radio station is programmed at the chosen preset number.

6Select and store all desired radio stations this way.

23

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Page User guide Prevent operating and maintenance problems Dear Magnavox product ownerFor Customer Use Español English Important Safety Instructions Do not defeat the safetyClass II equipment symbol EnglishSetup General InformationScope of supply Environmental informationControls EnglishPREV. / Exit Remote Control Remote control useEnglish Remote control buttons Connectors Analog audio connections English Monitor / TVConnections Digital audio connectionsVideo connections Done in your preferred languageStandby Power Speaker connectionsTV as the center speaker Antenna connections AM MW antennaSystem Setup Receiver adjustment Display English DisplayMenus Receiver menuYou can exit the menu at any time by pressing Menu structureSwitching the connection TV menuActivating Cinema Link Using one source selection for two or more appliances Source SelectionCHANNEL-DVD/SACD Input selection Reassigning a source selectionAdjusting the sound PLAYBACK, RecordingEnglish Playing a source Recording from a sourceAbout surround sound Switching surround sound Surround SoundSurround sound settings Night Mode only on the remote controlVirtual Surround Tuning to radio stations English Switching FM sensitivityTuner Storing radio stationsEnglish Tuning to stored radio stations Resorting stored radio stationsNaming radio stations Clearing station namesTechnical Data ReceiverGeneral OutputsTroubleshooting Limited Warranty MFX450eng 11/26/02 321 AM Estimado dueño del producto Magnavox Para uso del clienteInstrucciones Sobre Seguridad EspañolEL 6475-S002 01/6 Coloque el equipo exclusivamenteConfiguración Información GeneralLista de componentes Información medioambientalEspañol Mando a Distancia Utilización del mando a distanciaEspañol Botones del mando a distancia Para la toma de auriculares de 6,3 mm en la parte frontal Para los altavoces frontales izquierdo y derechoPara el altavoz central Para los altavoces envolventes izquierdo y derechoConexiones Conexiones de audio analógicas EspañolConexiones de audio digitales Español Sistema de control en bus, Cinema Link Conexiones de vídeoAlimentación Conexiones de las antenasEspañol Conexiones de los altavoces El TV como altavoz centralConfiguración DEL Sistema Ajuste del receptor Consulte las hojas de especificaciones de los altavocesPantalla Español PantallaMenús Menú del receptorEstructura del menú Menú del TV Activado de Cinema LinkActivación/desactivación de la conexión Selección DE Fuente Selección 6 CHANNEL-DVD/SACD InputPara reasignar una selección de fuente Acerca de 6 CHANNEL-DVD/SACD InputREPRODUCCIÓN, Grabación Español Reproducción de una fuenteAjuste del sonido Grabación de una fuenteSonido Envolvente Night Mode sólo en el mando a distancia Ajustes del sonido envolventeAmbiente virtual Sintonizador Para sintonizar las emisoras de radioAlmacenamiento de emisoras de radio Español Activación de la sensibilidad FMPara asignar un nombre a una emisora Para borrar los nombres de las emisorasPara reordenar emisoras de radio almacenadas Si cambia de ideaDatos Técnicos ReceptorAmplificador 10 % THD, 6 Ω, 1 kHz SalidasSolución DE Problemas Garantia Limitada English Español Meet Magnavox at the Internet 3140 115 IB8387T001/HK0241
Top Page Image Contents