Multiquip DCA-100SSJU operation manual Voltage Selector Switch- Single Phase 240/120V Position

Table of Contents

DCA-100SSJU — OUTPUT TERMINAL PANEL OVERVIEW

Voltage Selector Switch- Single Phase 240/120V Position

The following are additional voltages available when the voltage selector switch is in the single phase 240/120V position. (See Figure 36 below)

Single Phase: 120 Volt

The following connection, with the voltage selector switch locked into the single phase 240/120V position (See Figure 36), will offer SINGLE PHASE power at 120V. After hooking up the hard wires to the lugs as shown in figure 39 below, use the Voltage Regulator Knob to fine tune to 120V. (See Figure 37).

FIGURE 37. Voltage

Regulator Knob located

on the control panel

FIGURE 36. Voltage Selector Switch 240/120V Single Phase	FIGURE 39. Hard Wire Hookup for Single Phase, 120 volt
Position

Single Phase, 240 Volt

The following connection, with the voltage selector switch locked into the single phase 240/120V position (See Figure 36), will offer SINGLE PHASE power at 240V. After hooking up the hard wires to the lugs as shown in figure 38 below, use the Voltage Regulator Knob to fine tune to 240V. (See Figure 37)

FIGURE 38. Hard Wire Hookup for Single Phase 240 volt

DCA-100SSJU — PARTS AND OPERATION MANUAL (STD)— REV. #2 (05/03/01) — PAGE 41