Multiquip operation manual DCA-100SSJU Engine Operating Panel with KEY

Table of Contents

DCA-100SSJU — ENGINE OPERATING PANEL (WITH KEY)

The definitions below describe the controls and functions of the DCA-100SSJU " Engine Operating Panel " (Figure 9).

1.Panel light - Normally used in dark places or at night. When activated, panel will luminate. When the generator is not in use, turn the panel light switch to the ‘OFF’ position.

2.Panel light switch- When activated, will turn on control panel light.

3.Oil Pressure Gauge – Normal operation should be about 25 psi. When starting the generator the oil pressure may read a bit higher, but after the engine warms up the oil pressure should return to normal.

4.WaterTemperature Gauge – During normal operation this gauge be should read between 165oF to 215oF.

5.Charging Ammeter Gauge – Indicates the current being supplied by the engine’s alternator which provides current for generator’s control circuits and battery charging system.

6.Fuel Gauge - Indicates amount of diesel fuel available.

7.Tachometer – Indicates engine speed in RPM’s for 60 Hz operation. This meter should indicate 1800 RPM’s when the rated load is applied. In addition a built in hour meter will record the number of operational hours that the generator has been in use.

8.EngineThrottle Lever- This lever will change the speed of the engine from high to low.

9.Pre-Heat Button – Press hold this button to start the engine in cold conditions.

10.Starter Switch with Key – This switch has three different positions: Stop-Turn the key to stop the engine. Start-Turn the key to this position to start the engine. Release the key once the engine has started and it will automatically return to the operating position.

11.Oil Pressure Indicator - This indicator lets the operator know the oil pressure is dangerously high or low and will shut down the engine.

12.Water Temperature Indicator - This indicator lets the operator know the water temperature is dangerously high and will shut down the engine.

DCA-100SSJU — PARTS AND OPERATION MANUAL (STD)— REV. #2 (05/03/01) — PAGE 31