Delta 36-978 Mobile Base and Stand Assembly, Front and Side Panels, Short and Long LEG Supports

MOBILE BASE AND STAND ASSEMBLY

Put the stand together upside down for easier assembly.

FRONT AND SIDE PANELS

1.Insert a 5/16 -18 x 5/8" carriage head bolt (A) Fig. 1 through the leg (B) and the corresponding hole in the panel (C) Fig. 1.

NOTE: Make sure the squares of the bolt align with the flat sides of the hole opening.

2.Thread a 5/16 -18 serrated hex nut (D) Fig. 2 on the screw. Finger tighten the panel to the leg. Make sure that the serrated face of the hex nut is against the panel.

NOTE: Loosely tighten the hardware for further adjustment.

3.Fig. 3 shows all four legs attached to the front and side panels.

NOTE: Make sure that the short panels are opposite short panels and long panels are opposite long panels.

SHORT AND LONG LEG SUPPORTS

4.Attach the long side leg supports (E) Fig. 4 and the short side leg supports to the legs using 5/16 -18 x 5/8" carriage head bolts and 5/16 -18 serrated hex nuts. Insert the bolt through the leg first and then the support.

NOTE: Be sure the holes (J) Fig. 5 in all side supports are aligned.

5.Thread the hex nut on the bolt and finger tighten only. Attach eight screws and eight nuts in the holes - two of which are shown at (F) Fig. 5. Make sure these holes are on the bottom (after saw is turned upright).

CORNER BRACKETS

B A

C

Fig. 1

Fig. 3

F

J

Fig. 5

D

Fig. 2

E

Fig. 4

I

H

G

Fig. 6

6.Align the corner bracket (G) Fig. 6 that has the closed end with the holes (I) in the leg supports.

NOTE: Attach the closed-end brackets to the long leg support that has the 3 holes in the middle (Fig. 9). If necessary, use a soft hammer (or a regular hammer and block of wood) to tap the corner bracket to align the holes (Fig. 7).

7.Once aligned, attach the corner bracket to the leg supports using the 5/16 -18 x 5/8" carriage head bolts and 5/16 -18 serrated hex nuts. Insert the bolt through the support and the corner bracket at (K) Fig. 8. Thread a hex nut on the screw and tighten.

8.Attach the leg to the corner bracket usingthelonger5/16-18x3/4"carriage head bolts and 5/16-18 serrated hex nuts in the two holes, one of which is shown at (L) Fig. 8.

9.Repeat for the other corner bracket. You will install the rubber leveling feet on these brackets (G) Fig. 12.

10.Attach the brackets with the open end

(M)Fig. 10 the same as described in Steps 6 to 9.

Fig. 7

G

Fig. 9

K

L

Fig. 8

M

Fig. 10

11