Delta 36-979, 36-978 Hardware, Unpacking and Cleaning, Assembly Tools Required

HARDWARE

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

1.	7/16 - 20 x 1-1/4" Hex Head Bolt (6)	11.	1/4" External Tooth Lockwasher (4)
2.	5/16 -18 x 3/4" Carriage Head Bolt (8)	12.	1/4 -20 Hex Nut (1)
3.	5/16 -18 x 5/8" Carriage Head Bolt (50)	13.	1/4 -20 Wing Nut (1)
4.	1/4 -20 x 1-1/2" Hex Head Bolt (1)	14.	Spacer (1)
5.	1/4 -20 x 3/4" Hex Head Bolt (2)	15.	5/16 -18	Serrated Hex Nut (57)
6.	7/16" Flat Washer (6)	16.	5/16 -18 x 2-1/4” Hex Head Cap Bolt (2)
7.	5/16" Flat Washer (1)	17.	5/16 -18	Nylok Nut (2)
8.	1/4" Flat Washer (3)	18.	5/16 -18	Hex Jam Nut (5)
9.	7/16" Lockwasher (6)	19.	M4 x 8mm Pan Head Screw
10.	5/16" External Tooth Lockwasher (1)	20.	10mm Nylon Flat Washer (2)

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.

Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your saw.

After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

7/8" Open End Wrench (supplied)

7/8" and 1/2" Close End Wrench (supplied)

4mm Hex Wrench (supplied) 1/4” Hex Wrench (not supplied)

Socket or Open-End Wrenches, including 10mm, 12mm, 18mm,1/2 inch and a Phillips screwdriver (not supplied)

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes approximately 4-6 hours.

For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire instruction manual.

10