Husqvarna 966631102 Assembly, Assembling the blow pipe and control handle, Accessories, Handlebar

ASSEMBLY

Assembling the blow pipe and control handle

•Connect the blower and control pipe with the flexible hose. Clamp both ends of the flexible hose in place. Use the accompanying hardware.

1	4	2
3

1Flexible hose

2Control pipe

3Clamp

4Clamp

NOTE!

Lubricate the pipes a little to facilitate assembly.

•Fasten the handle holder to the control pipe and tighten the knob on the holder. Please make sure to align the handle holder with the convex of the control pipe.

•Adjust the position and angle to achieve a comfortable working position, and tighten.

•Use the clamp to fasten the cabling to the flexible hose. (BTS)

•Connect the straight pipe and pipe end. Push the pipes together and turn them so they lock.

Accessories

Handlebar

Disassemble the intermediate pipe. Disassemble the knob from the holder and puch the holder on to the holder pipe. Assemble the knob and tighten.

Assemble the intermediate pipe.

•If higher air speed is required, the round blow pipe is replaced by the flat nozzle.

1155849-49 Rev. 2 2013-03-22 English – 15