3Com 10002211 manual User, Documentation, software, contact 3Com Technical Support. See Appendix E

8COREBUILDER 6000 EXTENDED SWITCHING SOFTWARE REVISION 8.2.3

	After the software is loaded, this message appears:
	Installation complete.
	If the CoreBuilder executable software image stored in flash memory is
	corrupted (for example, when the power fails while you are updating
	software), contact 3Com Technical Support. See Appendix E.
6	To reboot the system to use the newly loaded software, enter:
	system reboot
	You are prompted with the following message:
	Are you sure you want to reboot the system (n/y) [y]:
7	At the prompt, enter y (for Yes).
	You are now ready to configure management access for your system. See
	the CoreBuilder 6000 Getting Started Guide.
User	This version of software is compatible with the documentation listed here.
Documentation	Some of this documentation may be available on CD-ROM. These release
	notes describe any changes and additions to this documentation.
■	CoreBuilder 6000 Getting Started Guide
■	CoreBuilder 6000 Control Panel User Guide
■	CoreBuilder 6000 Operation Guide
■	Corebuilder 6000 Administration Console User Guide
■	CoreBuilder 6000 Command Quick Reference (folded card)
■	LANplex 6000 Extended Switching User Guide
	The Extended Switching User Guide is shipped with Extended Switching
	software.
	Individual modules are shipped with their installation guides:
■	LMM+ (LANswitching Management Module +) Installation Guide
■	FCM (FDDI Concentrator Module) Installation Guide
■	EFSM (Ethernet/FDDI Switching Module) Installation Guide
■	TRSM (Token Ring Switching Module) Installation Guide
■	TMM Fast Ethernet (Tri-Media Module) Installation Guide