Manuals / 3Com / Computer Equipment / Switch

3Com 10002211 manual lp.mib - LANplex Systems MIB, version

Models: 10002211

1 86

Download 86 pages 29.2 Kb

Page 35

SNMP MIB Files

29

■lp.mib — LANplex Systems MIB, version 1.3.0

■lpOpFddi.mib — LANplex Optional FDDI MIB, version 1.2.1

■mib2.mib — MIB-II, RFC 1213

■rmon.mib — RMON MIB, RFC 1757

■srbridge.mib —Source Routing MIB RFC1525

■vlan.mib — LANplex VLAN MIB

Compiler Support ASN.1 MIB ﬁles are provided for each of the MIB compilers in this list. Any warnings or exceptions related to a compiler are listed with it.

■SMIC (version 1.0.9)

■MOSY (version 7.1)

For the MIB ﬁle lpOpFddi.mib, the MOSY compiler reports warnings for counter names that do not end in “s”. This report has no effect on the output produced by the MOSY compiler.

■HP Openview (version 3.1)

■mib2schema (with SunNet Manager version 2.0)

The MIB ﬁle fddiSmt7.mib produces the following warning messages when the ﬁle is compiled using mib2schema:

Translating....

Warning: The following INDEX entries in fddimibMACCountersTable not resolved:

fddimibMACSMTIndex fddimibMACIndex

Translation Complete.

Schema file in ÒfddiSmt7.mib.schemaÓ

Oid file in ÒfddiSmt7.mib.oidÓ

These warning messages have no effect on the ability of SunNet Manager to use the schema ﬁle generated with SunNet Manager versions 2.0 or later.

Image 35

3Com 10002211 manual lp.mib - LANplex Systems MIB, version

Contents

Published October 9,1997 Revision SOFTWARE INSTALLATION AND RELEASE NOTESCOREBUILDER 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Upgrading Your LMM or LMM+ CONTENTSCOREBUILDER 6000 EXTENDED SWITCHING SOFTWARE REVISION Hardware DependenciesB REMOTE MONITORING RMON TECHNOLOGY A IP MULTICAST ROUTINGC VLANS ON THE COREBUILDER SYSTEM D ADMINISTERING VLANSAccess by Digital Modem 3COM CORPORATION LIMITED WARRANTY3Com Bulletin Board Service Access by Analog ModemEXTENDED SWITCHING SOFTWARE COREBUILDEROverview Release Highlights Filter MIB Hard Disk Copying to the UNIX Platform 9 Remove diskette #4 using the following command the Setup dialog box Loading SystemSoftware on the LMM+To load the new software LANplex 6000 Extended Switching User Guide corrupted for example, when the power fails while you are updatingCorebuilder 6000 Administration Console User Guide CoreBuilder 6000 Command Quick Reference folded cardRevision 8.2.3? FDDI Switching Module FSM GuideFast Ethernet Switching Module FESM Guide What’s New atIP Interface Conﬁguration Change Enter subnet mask 255.255.0.0 Enter cost 7 Enter the advertisement address to be used on the interfaceExample Select IP stack by slot 1-3,5,7,9-12 1 Enter IP addressbridge stpFollowLinkState enableddisabled 12 COREBUILDER 6000 EXTENDED SWITCHING SOFTWARE REVISIONSample display of bridge port information corrections that are implemented at this release Revision 8.2.0?What’s New at What’s New at Revision 8.2.0? The system displays this message You receive the prompt to select each port’s duplex modetokenringfastEthernet duplexModeDefault To select the default all, press Return LOGGING OUT the other telnet session Logout the other telnet session? Y/N y Enter Password correctpasswordIncorrect password. Disconnecting DisconnectingThe system prompts you for port numbers 1 From the top level of the Administration Console, enterThe system prompts you for slot numbers The system prompts you for the port typeNote these additional items This message is immediately overwritten with System Issues The ESM supports only RMON groups 1 through VLAN statistics are not supported on the ESM Known Problems In the IMPORTS section, addA few lines below, add the following RowStatus comment Roving Analysis cannot monitor outgoing routed packets bridge.mib - Bridge MIB, RFC ethernet.mib - Ethernet MIB, RFC lp.mib - LANplex Systems MIB, version continued Support for IP routing on the FDDI Switching Module FSM30 COREBUILDER 6000 EXTENDED SWITCHING SOFTWARE REVISION Revision History 32 COREBUILDER 6000 EXTENDED SWITCHING SOFTWARE REVISION Support for Single Mode Fiber SMF on the FCM modulelpBridgePortAddressLearnedEvent and The Ethernet MIB attributes, requestedEnabledPaths and34 COREBUILDER 6000 EXTENDED SWITCHING SOFTWARE REVISION Overview IP MULTICAST ROUTINGLANplex 6000 Extended Switching User Guide Disabling IGMP disabledEnabling and Disabling DVMRPInterfaces Administering IPMulticast Rate Limit Enter an IP interface index ip multicast interface disableip multicast interface enable Select IP stack by slot 2,3,7,9-12allthat require a tunnel are those that require a connection between two AdministeringMulticast Tunnels multicast internetworks through one or more unicast routersEnter the index numbers of the interfaces with which you want to The destination router cannot be directly connected to the samesubnetworks as the local IP address Enter the slots of the switching module for which you want to view IP Displaying RoutesTable A-1 describes the ﬁelds in the route display The following display shows all available multicast routesfor packets observed on the system. The multicast cache shows you how Displaying theMulticast Cache A-11 The following display shows the multicast cache conﬁgurationDisplaying the Multicast Cache Set of interfaces on which the traffic will be flooded out. I repre Table A-2 describes the ﬁelds in the CacheDisplaybracket indicate a multicast subnetwork. Entries without an Interface number on which that gateway is connected. Traffic isREMOTE MONITORING RMON B TECHNOLOGY suite of applications CoreBuilderRMON ImplementationRMON Groups Number of received octets Number of received packets per interface for each time interval includes Figure B-1 shows a counter with thresholds set manually Setting Alarm ThresholdsExample of an Alarm Threshold RMON Hysteresis Mechanism B-8 APPENDIX B REMOTE MONITORING RMON TECHNOLOGY 3Com Transcend RMON AgentsFigure B-2 shows an example of the CoreBuilder RMON implementation Management Information Base MIBThe displayed information includes these items COREBUILDER SYSTEM VLANS ON THEAbout VLANs C-2 APPENDIX C VLANS ON THE COREBUILDER SYSTEM Port Group VLANsMAC Address Group VLANS Application-Oriented VLANSAbout VLANs CoreBuilder Protocol-Sensitive VLAN ConﬁgurationProtocol-Sensitive VLANS Protocol SuiteThe ﬂood domain for protocols not supported by any VLAN in the system Layer 3 Addressing InformationModifying the Default VLAN VLAN Exception Flooding For example, two IP VLANs can be conﬁgured for ports 1-10 as follows Overlapped IP VLANsRouting Between VLANs Displaying VLAN Information ADMINISTERING VLANSExample of a detailed display for the VLANs D-2 APPENDIX D ADMINISTERING VLANSExample of a summary display for several VLANs Number of flooded broadcast and multicast bytes that were to set up flood domains for overlapping IP VLAN subnetworksTable D-1describes these statistics SNA,Vines,X.25,NetBIOS,default Deﬁning VLANInformation for a Traditional BridgeThe maximum number of VLANs you can deﬁne on a single bridge is Information for an HSI Switch EngineD-6 APPENDIX D ADMINISTERING VLANS bridge vlan modify ExampleModifying VLAN Information Select bridges by slot 2-3,5,10-12all Select VLAN indexes 1-2all bridge vlan removeSelect menu option bridge/vlan remove TECHNICAL SUPPORT ServicesOnline Technical Service1 408 654 Access by Analog ModemAccess by Digital Modem Local access numbers are available within the following countries 305 261 3266 Miami, Florida Santa Clara, CaliforniaCzech Republic/Slovak Central European HQTo obtain an RMA number, call or fax Page SOFTWARE 3Com Corporation LIMITED WARRANTYSTANDARD WARRANTY SERVICE HARDWARE3Com Corporation, 5400 Bayfront Plaza, Santa Clara, CA 95052-8145 408 LIMITATION OF LIABILITYGOVERNING LAW you specific legal rights which may vary depending on local law