3Com 2500 manual To display the contents of the routing table, from the Administration

11-6 CHAPTER 11: ADMINISTERING IPX ROUTING

Displaying the You can display the routing tables for the system to determine which Routing Table routes are configured and if they are operational.

				To display the contents of the routing table, from the Administration
				Console top-level menu, enter:
Top-Level Menu				ipx route display
system
ethernet	interface
fddi	➧route	➧display		The example displays the configuration of IPX forwarding, RIP, and SAP,
atm	server	static		as well as the routing table.
bridge	forwarding	remove
ip	rip	flush
➧ipx	enhanced
appletalk	sap		IPX forwarding is enabled, RIP is active, SAP is active
snmp	statistics
analyzer			Interface		Address	Hops	Tics	Node	Age
script
logout			2		45469f02	5	6	08-00-02-04-80-b6	44
			2		c2c028ca	4	28	08-00-02-04-80-b6	85
			2		aaaaaaaa	6	671	08-00-02-04-80-b6	85

Defining a Static Route

Top-Level Menu
system
ethernet	interface
fddi	➧route	display
atm	server	➧static
bridge	forwarding	remove
ip	rip	flush
➧ipx	enhanced
appletalk	sap
snmp	statistics
analyzer
script
logout

Before you define static routes on the system, you must define at least one IPX interface. See the section “Defining an IPX Interface” on page 11-3. Static routes remain in the table until you remove them or until you remove the corresponding interface. Static routes take precedence over dynamically learned routes to the same destination. You can set up to 16 static routes.

To define a static route:

1From the Administration Console top-level menu, enter:

ipx route static

2Enter the 4-byte IPX network address of the route.

3Enter the cost of the route.

4Enter the interface number of the route.