3Com 2500 manual ip interface define, Administering Ip Routing

9-4 CHAPTER 9: ADMINISTERING IP ROUTING

Example summary display:

IP routing is enabled, RIP is active,

ICMP discovery is disabled.

Index	Type	IP address	Subnet mask	Cost	State VLAN Index
1	VLAN	158.101.1.1	255.255.255.0	1	Down	2
Index Type		IP address	Subnet mask	Cost	State Port
2	LIS	158.101.112.1	255.255.255.0	1	Up	1

Example detail display:

IP forwarding is enabled, RIP is active,

ICMP discovery is disabled.

Index	Type	IP address	Subnet mask	Cost	State VLAN index
1	VLAN	158.101.1.1	255.255.255.0	1	Down	2
Index	Type	IP address	Subnet mask	Cost	State Port
2	LIS	158.101.112.1	255.255.255.0	1	Up	1

4 Advertisement Addresses:
158.101.112.200 158.101.112.203 158.101.112.204			158.101.112.205
atmArpServer
47-0000-00-000000-0000-0000-00cc-080001200054-ff
maxSvcCount	inactivityTime	minHoldingTime
0	1200		60

1PVC:

1/32

Defining an IP LIS

				Interface
Top-Level Menu
system
	➧interface
ethernet
fddi		route		summary
atm		arp		detail
bridge		atmArpServer
			➧define
➧ip		multicastmodify
ipx		udpHelper
	routing			remove
appletalk				addAdvertisement	1
snmp		rip		removeAdvertisement
analyzer				addPVC
script		ping		removePVC
logout		statistics

When you define an IP LIS interface, you specify several general IP interface characteristics and IP LIS characteristics.

Before you define an IP LIS interface with SVCs, be sure you have defined an ATM ARP server as described in the section “Administering ATM ARP Servers” later in this chapter. If the LIS interface has only PVCs, you do not need to define an ATM ARP server.

To define an IP interface:

From the top level of the Administration Console, enter:

ip interface define