3Com 2500 manual appletalk interface display, appletalk interface define

Administering Interfaces 12-3

Displaying AppleTalk Interfaces

Top-Level Menu
system
	➧interface
ethernet
fddi	route	➧display
atm	aarp	define
bridge	zone	remove
ip	forwarding
ipx	checksum

➧appletalk ping

snmp statistics analyzer

script logout

You can display a table that shows all AppleTalk interfaces and their parameter settings configured for the system.

To display the AppleTalk interfaces defined on the router, from the Administration Console top-level menu, enter:

appletalk interface display

Example:

DDP forwarding is enabled.
Index	Network Range	Address	State	VLAN index
1	20112-20112	20112.27	enabled	3
2	20124-20124	20124.1	enabled	2
3	20125-20125	20125.1	enabled	4

Defining an

Interface

Top-Level Menu
system
	➧interface
ethernet
fddi	route	display
atm	aarp	➧define
bridge	zone	remove
ip	forwarding
ipx	checksum

➧appletalk ping

snmp statistics analyzer

script logout

When you define an interface, you define the interface’s network range, zone name, and the VLAN index associated with the interface. You must define an AppleTalk VLAN before you define the AppleTalk interface to associate with that VLAN.

To define an AppleTalk interface:

1At the Administration Console’s top-level menu, enter:

appletalk interface define

You are prompted for the interface’s parameters. To use the value in brackets, press [Return] at the prompt.

The following message appears:

Configure seed interface? (n,y) [y]:

2Enter n (no) or y (yes).

3Enter the start of the network range associated with the interface.

4Enter the end of the network range associated with the interface.

5Enter the default zone name.

The default zone name is used by clients that have not been configured to use a particular zone.