3Com 2500 manual Server Table servers are learned and if they are operational

Administering Servers 11-9

Displaying the You can display the server table for the system to determine which

		Server Table servers are learned and if they are operational.
				To display the contents of the server table, from the Administration
Top-Level Menu				Console top-level menu, enter:
system
ethernet	interface			ipx server display
fddi	route		➧display
atm	➧server		static
bridge	forwarding		remove
ip	rip		flush
➧ipx	enhanced
appletalk	sap
snmp	statistics
analyzer
script
logout	IPX forwarding is enabled, RIP is active, SAP is active
		Interface		Name	Type Network	Node Socket	Hops	Age
			2	GB201	39b 8c141bfe	08-00-02-04-80-b6 8059	4	73
			2	GB3COM2	39b af0bc60f	00-00-00-00-00-01 85fa	4	85

Defining a Static Server

Top-Level Menu
system
ethernet	interface
fddi	route	display
atm	➧server	➧static
bridge	forwarding	remove
ip	rip	flush
➧ipx	enhanced
appletalk	sap
snmp	statistics
analyzer
script
logout

Before you define static servers on the system, you must define at least one IPX interface. See the section “Defining an IPX Interface” on page 11-3. Static servers remain in the table until you remove them or until you remove the corresponding interface. Static servers take precedence over dynamically learned servers to the same destination. You can have a maximum of eight static servers.

To define a static server:

1From the Administration Console top-level menu, enter:

ipx server static

2Enter the interface number of the server.

3Enter the service type of the server.

4Enter the service name of the server.

5Enter the IPX network address of the server.

6Enter the socket value of the server.

7Enter the node address of the server.