DUA1640-5AAA02
Giving the Stack an IP Address B-11
2Enter the relevant information into the I P Setup dialog box or Easy
Setup dialog boxes and click OK to exit the dialog boxes.
3Reset the hub for any changes to take effect.
After resetting the hub, you may need to select ResetView from the
File menu to restart communication using the new information.
CAUTION: Always make a note of any changes that you make to the
settings on this dialog box.
If you are communicating with the stack over the network (Windows
‘95 and Windows NT only) and you ch ange the IP address of the hub,
you need to change the Device Network IP Address entry in the Device
Access dialog box (refer to “Accessing the Stack” on page B-8) to
continue managing the stack over the net work.
If you are using SLIP (Quick Config Mana ger over the console port),
ensure that Flow Cont rol is not set to XON/XOFF (by default, it is set to
None). Unless you need to connect to the stack through a modem, do
not change the console port or SLIP default settings. For information on
the console port, refer to “Changing the Console Port Settings” on
page B-27. If you require more information on SLIP, read the Internet
Activities Board document RFC 155.
Quick Config Manager doe s not have a facility to receive traps.