DUA1640-5AAA02
3-6 CHAPTER 3: USING THE PS HUB
Positioning the PS Hub When installing your PS Hub, ensure that:
■It is accessible and cables can be connect ed easily.
■It is out of direct sunlight and away from sources of he at.
■Cabling is away from power lines, fluorescent lighting fixtu res, and
sources of electrical noise such as radios, transmitters and
broadband amplifiers.
■Water or moisture can not enter the case of the un it.
■Air flow around the unit and through the vents in the si de of the
case is not restricted. We recommend you provide a minimum of
25.4mm (1in.) clearance.
■Free standing hubs are not stacked more than six high, and that
cables are supported so that they cannot pull the stack over.
■No objects are placed on top of any hub or stack.
Using the Rubber Feet Four standard height and two reduced height sel f-adhesive rubber feet
are supplied with the hub.
Do not apply the feet if you intend to rack or wall mount the hub.
Usage of the feet depends on where the PS Hub is placed:
■If the hub is going to be placed on top o f a flat surface or another
PS Hub, use the four standard height feet.
■If the hub is going to be placed on top o f a LinkBuilder® FMS™ II
hub or other SuperStack II unit, use two standard height feet
towards the front, a nd the two reduced heigh t feet towards the
rear.
CAUTION: If the hub is to be part of a free standing stack, apply the
feet to each marked corner area on the underside of the hub. If the
free standing stack contains different size hubs, ensure that the larger
hubs are at the bottom of the stack.