3Com Switch 8800 Configuration Guide Chapter 32 ACL Configuration
32-10

32.2.4 Activating ACL

After defining an ACL, you must activate it. This configuration activates those ACLs to
filter or classify the packets forwarded by hardware.
For interface cards, perform the following configurations in Ethernet port view or port
group view.
Table 32-11 Activate ACL
Operation Command
Activate IP group ACL packet-filter inbound ip-group { acl-number |
acl-name } [ rule rule [ system-index index ] ]
Deactivate IP group ACL undo packet-filter inbound ip-group { acl-number |
acl-name } [ rule rule ]
Activate IP group ACL
and link group ACL at
same time
packet-filter inbound ip-group { acl-number |
acl-name } { rule rule link-group { acl-number |
acl-name } [ rule rule [ system-index index ] ] |
link-group { acl-number | acl-name } rule rule }
Deactivate IP group ACL
and link group ACL at
same time
undo packet-filter inbound ip-group { acl-number |
acl-name } { rule rule link-group { acl-number |
acl-name } [ rule rule ] | link-group { acl-number |
acl-name } rule rule }
Activate link group ACL packet-filter inbound link-group { acl-number |
acl-name } [ rule rule [ system-index index ] ]
Deactivate link group
ACL undo packet-filter inbound link-group { acl-number |
acl-name } [ rule rule ]
system-index index here is the system index for an ACL rule. When delivering a rule,
the system assigns an index to it, for convenience of later retrieval. You can also assign
a system index for it when activating an ACL rule with this command. However, you are
not recommended to assign a system index if not urgently necessary.
32.3 Displaying and Debugging ACL Configurations
After these configurations are completed, you can use the display command in any
view to view ACL running to check configuration result. You can clear ACL statistics
using the display command in user view.
Table 32-12 Display and debug ACL configurations
Operation Command
Display time range configuration display time-range { all | name }