96CHAPTER 4: USING RF
Place Your | You will need to unpack and physically install your WX switches and |
Equipment | MAPs. For information about installing your equipment, see “Equipment |
| Installation” on page 40. |
|
|
Configure Initial | After installing a WX switch, you must prepare it for configuration and |
WX Switch | management by 3WXM, by configuring IP connectivity between the WX |
Connectivity | and 3WXM. Use the Web Quick Start (if available), or enter the |
| quickstart command at the CLI prompt. |
| For more information about configuring initial WX switch connectivity, |
| see the Wireless LAN Switch and Controller Quick Start Guide. |
| An administrative certificate is also required on the WX switch to enable |
| management access by 3WXM. If the switch does not already have |
| certificates, MSS automatically generates them the first time you boot |
| using MSS Version 4.2 or later. You do not need to install certificates |
| unless you want to replace the ones automatically generated by MSS. (For |
| more information, see the “Certificates Automatically Generated by |
| MSS” section in the “Managing Keys and Certificates” chapter of the |
| Wireless LAN Switch and Controller Configuration Guide.) |
Upload the WX Switch Configuration into a 3WXM Network Plan
Retrieve the basic configuration information you added to the WX switch and upload it into 3WXM.
To upload the WX switch configuration into a 3WXM network plan
1Select the Configuration tool bar option.
2In the Task List panel, select Upload Wireless Switch.
3In the IP Address box, type the IP address for the WX switch.
4In the Enable Password box, type the enable password for the WX switch.
This password must match the enable password that was defined using the CLI command set enablepass. For more information, see the Wireless LAN Switch and Controller Configuration Guide.
5Click Next. The uploading progress is shown.
6After the Successfully uploaded device message is displayed, click Next.
