54 CHAPTER 3: CONFIGURING WIRELESS SERVICES
In general, these same steps are required to configure other services, too.
You can refer back to this section, using the summary list or the task
table, with configuration options for “Configure Guest Access Services”
on page 67 or “Configure Voice over Wireless IP Service” on page 81.
Create a Radio Profile
You configure a radio profile to set attributes that you can apply to
multiple radios. Rather than configuring each radio individually, the radio
profile is applied to multiple radios that you select. Service profiles are
mapped to radio profiles.
The radio profile can contain RF Auto-Tuning settings and IEEE 802.11
settings that control how the data is received and transmitted.
MAPs (and consequently, radios) need to be added to 3WXM after
creating a radio profile. For more information about adding radios, refer
to one of the following:
“Using RF Auto-Tuning” on page95
“Using RF Auto-Tuning with Modelling” on page103
“Using RF Planning” on page 119
To create a radio profile
1Select Configuration on the toolbar.
2In the Organizer panel, expand the WX switch.
3Expand Wireless, then select Radio Profiles.
4In the Task List panel, select Radio Profile.
The Create Radio Profile wizard is displayed.