3M 800rf Maintenance And Repairs, Safety Measures see section, Operation, Frequency, Qualification

13-MAINTENANCE AND REPAIRS

13.1 Safety Measures (see section 3)

Carrying out maintenance and repairs may imply the necessity to work in dangerous situations.

13.2Tools and Spare Parts Supplied with the Machine

See Spare Parts Order Section.

13.3 Recommended Frequency of Inspection and Maintenance Operations

Operation	Frequency	Qualification	Sections
Inspection safety features	daily	1	13.4
Cleaning of machine	weekly	1	13.5
Cleaning of cutter blade	weekly	2	13.6
Oiling of felt pad	weekly	2	13.7
Lubrication	monthly	2	13.7-13.8
Blade replacement	when worn	2	See Manual 2
Drive belt replacement	when worn	2	13.10

13.4Inspections to be Performed Before and After Every Maintenance Operation

Before every maintenance operation, turn the main switch OFF (O) and disconnect. During the mainte- nance operation, only properly trained and qualified personnel must work on the machine. At the end of every maintenance operation check the safety devices.

13.5 Check Efficiency of Safety Features

1.Blade guard assembly upper taping head

2.Blade guard assembly lower taping head

3.Latching Emergency stop button with mechanical lock (interrupt supply of electrical power)

4.Turn the main switch STOP/OFF (O)

5.Safety guards top drive belts

13.6 Cleaning of Machine

Qualification 1

A weekly cleaning with dry rags or diluted detergents is necessary. Cardboard boxes produce a significant quantity of dust and paper chips when processed or handled in case sealing equipment. If this dust is allowed to build up on machine components, it can cause component wear and over-heating of drive motors. The dust build up is best removed from the machine with a vacuum cleaner. Depending on the number of cartons processed, this cleaning should be done weekly. Excessive build-up that cannot be removed by vacuuming should be removed with a damp cloth.

800rf-NA

41

13.7 Cleaning of Cutter Blade

Qualification 2

Should tape adhesive build-up occur, carefully wipe clean with oily cloth or brush (Figure 13-1).Oil pre- vents the build-up of tape adhesive.

(See manual 2.)

WARNING

•To reduce the risk associated with mechanical and electrical hazards:

−Read, understand, and follow all safety and operating instructions before operating or servicing the case sealer.

−Allow only properly trained and qualified personnel to operate and service this equipment.

•To reduce the risk associated with pinches, entanglement and hazardous voltage:

−Turn electrical and air supply off and disconnect before performing any adjust- ments, maintenance or servicing the machine or taping heads.

2012 March